[PATCH net v4 4/7] net: dsa: mt7530: fix handling of BPDUs on MT7530 switch

[Arınç ÜNAL]

On 14.06.2023 23:50, Vladimir Oltean wrote:
> On Mon, Jun 12, 2023 at 10:59:42AM +0300, arinc9.unal at gmail.com wrote:
>> From: Arınç ÜNAL <arinc.unal at arinc9.com>
>>
>> BPDUs are link-local frames, therefore they must be trapped to the CPU
>> port. Currently, the MT7530 switch treats BPDUs as regular multicast
>> frames, therefore flooding them to user ports. To fix this, set BPDUs to be
>> trapped to the CPU port.
>>
>> BPDUs received from a user port will be trapped to the numerically smallest
>> CPU port which is affine to the DSA conduit interface that is up.
>>
>> Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch")
>> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
>> ---
>>   drivers/net/dsa/mt7530.c | 4 ++++
>>   1 file changed, 4 insertions(+)
>>
>> diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
>> index 2bde2fdb5fba..e4c169843f2e 100644
>> --- a/drivers/net/dsa/mt7530.c
>> +++ b/drivers/net/dsa/mt7530.c
>> @@ -2259,6 +2259,10 @@ mt7530_setup(struct dsa_switch *ds)
>>   
>>   	priv->p6_interface = PHY_INTERFACE_MODE_NA;
>>   
>> +	/* Trap BPDUs to the CPU port */
>> +	mt7530_rmw(priv, MT753X_BPC, MT753X_BPDU_PORT_FW_MASK,
>> +		   MT753X_BPDU_CPU_ONLY);
>> +
>>   	/* Enable and reset MIB counters */
>>   	mt7530_mib_reset(ds);
>>   
>> -- 
>> 2.39.2
>>
> 
> Where have you seen the BPC register in the memory map of MT7530 or MT7621?

I did not somehow dump the memory map of the switch hardware and confirm 
the BPC register is there, if that's what you're asking.

However, I can confirm the register is there and identical across all 
MT7530 variants. I have tested the function of the register on the MCM 
MT7530 on the MT7621 SoC and the standalone MT7530. The register is also 
described on the document MT7620 Programming Guide v1.0, page 262.

Arınç