[PATCH] i2c: imx-lpi2c: add debug message when i2c peripheral clk doesn't work

[Andi Shyti]

Hi,

On Mon, May 29, 2023 at 03:23:16PM +0800, carlos.song at nxp.com wrote:
> From: Gao Pan <pandy.gao at nxp.com>
> 
> Add debug message when i2c peripheral clk rate is 0, then
> directly return -EINVAL.
> 
> Fixes: a55fa9d0e42e ("i2c: imx-lpi2c: add low power i2c bus driver")
> Signed-off-by: Gao Pan <pandy.gao at nxp.com>
> Signed-off-by: Carlos Song <carlos.song at nxp.com>
> ---
>  drivers/i2c/busses/i2c-imx-lpi2c.c | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/i2c/busses/i2c-imx-lpi2c.c b/drivers/i2c/busses/i2c-imx-lpi2c.c
> index 11240bf8e8e2..62111fe9f207 100644
> --- a/drivers/i2c/busses/i2c-imx-lpi2c.c
> +++ b/drivers/i2c/busses/i2c-imx-lpi2c.c
> @@ -209,6 +209,11 @@ static int lpi2c_imx_config(struct lpi2c_imx_struct *lpi2c_imx)
>  	lpi2c_imx_set_mode(lpi2c_imx);
>  
>  	clk_rate = clk_get_rate(lpi2c_imx->clks[0].clk);
> +	if (!clk_rate) {
> +		dev_dbg(&lpi2c_imx->adapter.dev, "clk_per rate is 0\n");
> +		return -EINVAL;
> +	}

should this rather be a dev_err?

And, BTW, did you actually hit this?

Andi

> +
>  	if (lpi2c_imx->mode == HS || lpi2c_imx->mode == ULTRA_FAST)
>  		filt = 0;
>  	else
> -- 
> 2.34.1
>