[PATCH v1 3/3] dt-bindings: thermal: sun8i: Add binding for D1/T113s THS controller

[Maxim Kiselev]

сб, 10 июн. 2023 г. в 21:01, Conor Dooley <conor at kernel.org>:

...

> > > > +  - |
> > > > +    thermal-sensor at 2009400 {
> > > > +          compatible = "allwinner,sun20i-d1-ths";
> > > > +          reg = <0x02009400 0x400>;
> > > > +          interrupts = <0 90 0>;
> > > > +          clocks = <&ccu 0>;
> > > > +          clock-names = "bus";
> > > > +          resets = <&ccu 2>;
> > > > +          nvmem-cells = <&ths_calibration>;
> > > > +          nvmem-cell-names = "calibration";
> > > > +          #thermal-sensor-cells = <0>;
> > > >
> > > >> Is this calibration required, or optional, for the d1?
> > >
> > > Calibration data for the D1 is optional as for the H6.
> > > (But without it, the sensor data will be inaccurate).
> >
> > Okay. Modulo the signoff:
> > Reviewed-by: Conor Dooley <conor.dooley at microchip.com>
>
> Wait, that's not what I meant to say... Clearly turned my brain off for
> a moment. If it is not going to function correctly without the
> calibration data, why not make the calibration data required for the
> d1's ths?

I don't really know why, but the calibration data is optional for
other controllers.
So I just did it the same way.
Here is explanation comment about it from the driver:
        /*
         * Even if the external calibration data stored in sid is
         * not accessible, the THS hardware can still work, although
         * the data won't be so accurate.
         *
         * The default value of calibration register is 0x800 for
         * every sensor, and the calibration value is usually 0x7xx
         * or 0x8xx, so they won't be away from the default value
         * for a lot.
         *
         * So here we do not return error if the calibration data is
         * not available, except the probe needs deferring.
         */