[GIT PULL] arm64: dts: ZynqMP DT changes for v6.5
Michal Simek
monstr at monstr.eu
Thu Jun 8 05:22:37 PDT 2023
Hi,
please pull these changes to your tree.
Thanks,
Michal
The following changes since commit ac9a78681b921877518763ba0e89202254349d1b:
Linux 6.4-rc1 (2023-05-07 13:34:35 -0700)
are available in the Git repository at:
https://github.com/Xilinx/linux-xlnx.git tags/zynqmp-dt-for-v6.5
for you to fetch changes up to 067bf44de11ceae0d2787c86127a39a67b2d60a6:
dt-bindings: usb: xilinx: Replace Manish by Piyush (2023-06-05 13:18:32 +0200)
----------------------------------------------------------------
arm64: ZynqMP DT changes for v6.5
Various small fixes and cleanups to be aligned with the latest dt-schema.
Other major changes are:
- Wire mali-400 gpu
- Change board name for zcu1275
- Use ethernet-phy-id to handle ETH phy reset properly
- Switch to amd.com emails
- Update people in DT bindings
----------------------------------------------------------------
Amit Kumar Mahapatra (2):
arm64: zynqmp: Add mtd partition for secure OS storage area
arm64: zynqmp: Set qspi tx-buswidth to 4
Ashok Reddy Soma (1):
arm64: zynqmp: Fix usb node drive strength and slew rate
Michal Simek (24):
dt-bindings: arm: xilinx: Change zc1275 board name to zcu1275
arm64: zynqmp: Change zc1275 board name to zcu1275
Revert "arm64: dts: zynqmp: Add address-cells property to interrupt
controllers"
arm64: zynqmp: Rename ams_ps/pl node names
arm64: zynqmp: Sync node name address with reg (mailbox)
arm64: zynqmp: Fix usb reset over bootmode pins on zcu100
arm64: zynqmp: Add dmas, dp, rtc, watchdogs and opp nodes for SOM
arm64: zynqmp: Use assigned-clock-rates for setting up SD clock in SOM
arm64: zynqmp: Add gpio labels for modepin gpio
arm64: zynqmp: Add pinctrl emmc description to SM-K26
arm64: zynqmp: Switch to ethernet-phy-id in kv260
arm64: zynqmp: Setup clock for DP and DPDMA
arm64: zynqmp: Enable DP driver for SOMs
arm64: zynqmp: Enable AMS on SOM and other zcu10x boards
arm64: zynqmp: Describe bus-width for SD card on KV260
arm64: zynqmp: Add phase tags marking
arm64: xilinx: Use zynqmp prefix for SOM dt overlays
dt-bindings: xilinx: Switch xilinx.com emails to amd.com
arm64: zynqmp: Convert kv260-revA overlay to ASCII text
arm64: zynqmp: Switch to amd.com emails
arm64: zynqmp: Describe TI phy as ethernet-phy-id
arm64: zynqmp: Used fixed-partitions for QSPI in k26
dt-bindings: xilinx: Remove Rajan, Jolly and Manish
dt-bindings: usb: xilinx: Replace Manish by Piyush
Parth Gajjar (2):
dt-bindings: gpu: mali-utgard: Add xlnx,zynqmp-mali compatible
arm64: zynqmp: Add mali-400 gpu node for zynqmp
Piyush Mehta (1):
arm64: zynqmp: Disable USB3.0 for zc1751-xm016-dc2
Radhey Shyam Pandey (1):
arm64: zynqmp: Add pmu interrupt-affinity
Sai Krishna Potthuri (1):
arm64: zynqmp: Add resets property to sdhci nodes
Srinivas Neeli (1):
arm64: zynqmp: Add linux,code for gpio button
Documentation/devicetree/bindings/arm/xilinx.yaml
| 8 +-
Documentation/devicetree/bindings/ata/ceva,ahci-1v84.yaml
| 2 +-
Documentation/devicetree/bindings/clock/xlnx,clocking-wizard.yaml
| 2 +-
Documentation/devicetree/bindings/clock/xlnx,versal-clk.yaml
| 4 +-
Documentation/devicetree/bindings/crypto/xlnx,zynqmp-aes.yaml
| 4 +-
Documentation/devicetree/bindings/firmware/xilinx/xlnx,zynqmp-firmware.yaml
| 2 +-
Documentation/devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml
| 2 +-
Documentation/devicetree/bindings/fpga/xlnx,versal-fpga.yaml
| 2 +-
Documentation/devicetree/bindings/fpga/xlnx,zynqmp-pcap-fpga.yaml
| 2 +-
Documentation/devicetree/bindings/gpio/gpio-zynq.yaml
| 2 +-
Documentation/devicetree/bindings/gpio/xlnx,gpio-xilinx.yaml
| 2 +-
Documentation/devicetree/bindings/gpio/xlnx,zynqmp-gpio-modepin.yaml
| 2 +-
Documentation/devicetree/bindings/gpu/arm,mali-utgard.yaml
| 1 +
Documentation/devicetree/bindings/i2c/cdns,i2c-r1p10.yaml
| 2 +-
Documentation/devicetree/bindings/mailbox/xlnx,zynqmp-ipi-mailbox.yaml
| 2 +-
Documentation/devicetree/bindings/media/xilinx/xlnx,csi2rxss.yaml
| 2 +-
Documentation/devicetree/bindings/memory-controllers/snps,dw-umctl2-ddrc.yaml
| 3 +-
Documentation/devicetree/bindings/memory-controllers/xlnx,zynq-ddrc-a05.yaml
| 3 +-
Documentation/devicetree/bindings/pci/xilinx-versal-cpm.yaml
| 2 +-
Documentation/devicetree/bindings/pinctrl/xlnx,zynq-pinctrl.yaml
| 2 +-
Documentation/devicetree/bindings/pinctrl/xlnx,zynqmp-pinctrl.yaml
| 3 +-
Documentation/devicetree/bindings/power/reset/xlnx,zynqmp-power.yaml
| 2 +-
Documentation/devicetree/bindings/rtc/xlnx,zynqmp-rtc.yaml
| 2 +-
Documentation/devicetree/bindings/serial/cdns,uart.yaml
| 2 +-
Documentation/devicetree/bindings/spi/spi-cadence.yaml
| 2 +-
Documentation/devicetree/bindings/spi/spi-xilinx.yaml
| 2 +-
Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.yaml
| 2 +-
Documentation/devicetree/bindings/spi/xlnx,zynq-qspi.yaml
| 2 +-
Documentation/devicetree/bindings/timer/cdns,ttc.yaml
| 2 +-
Documentation/devicetree/bindings/usb/dwc3-xilinx.yaml
| 2 +-
Documentation/devicetree/bindings/usb/xlnx,usb2.yaml
| 2 +-
Documentation/devicetree/bindings/watchdog/xlnx,xps-timebase-wdt.yaml
| 4 +-
arch/arm64/boot/dts/xilinx/Makefile
| 18 +-
arch/arm64/boot/dts/xilinx/avnet-ultra96-rev1.dts
| 2 +-
arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi
| 21 +-
arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
| 28 +-
arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
| 22 +-
arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
| 327 +++++++++++++++-----
arch/arm64/boot/dts/xilinx/zynqmp-smk-k26-revA.dts
| 2 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts
| 4 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts
| 6 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts
| 15 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm016-dc2.dts
| 12 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm017-dc3.dts
| 2 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts
| 8 +-
arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm019-dc5.dts
| 4 +-
arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
| 38 ++-
arch/arm64/boot/dts/xilinx/zynqmp-zcu102-rev1.0.dts
| 2 +-
arch/arm64/boot/dts/xilinx/zynqmp-zcu102-rev1.1.dts
| 2 +-
arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
| 48 ++-
arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revB.dts
| 27 +-
arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts
| 48 ++-
arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts
| 48 ++-
arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts
| 35 ++-
arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts
| 35 ++-
arch/arm64/boot/dts/xilinx/{zynqmp-zc1275-revA.dts =>
zynqmp-zcu1275-revA.dts} | 10 +-
arch/arm64/boot/dts/xilinx/zynqmp.dtsi
| 40 ++-
57 files changed, 633 insertions(+), 249 deletions(-)
rename arch/arm64/boot/dts/xilinx/{zynqmp-zc1275-revA.dts =>
zynqmp-zcu1275-revA.dts} (73%)
More information about the linux-arm-kernel
mailing list