[PATCH 2/3] thermal: qoriq_thermal: only enable supported sensors

[Daniel Lezcano]

On 07/06/2023 19:42, Sebastian Krzyszkowiak wrote:

[ ... ]

>> Hence, the thermal_zone_device_register_with_trips() is not called, the
>> thermal zone is not created neither updated.
> 
> Again - that's not the case the check is there for. It's there for zones that
> do exist and that do get registered, because REGS_TMR only gets set *after*
> all the zones are already registered (the driver as it is right now does not
> know which sites it should enable before registering the zones). Because of
> that, the first value a zone gets after being registered is always bogus,
> because no monitoring site has been enabled yet at all.

Ok, I misunderstood. I thought that was for failing registered thermal zone.

Would enabling the site in ops->change_mode do the trick ?







-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog