[PATCH v2 00/10] Add devicetree support for SDX75 Modem and IDP

[Rohit Agarwal]

Hi,

Changes in v2:
 - Added the CPUFreq support patch.
 - Collected the Acked by tags.
 - Addressed some minor comments from Konrad.

This series adds devicetree support for Qualcomm SDX75 platform and IDP
board. This series functionally depends on GCC and RPMh Clock support
series [1], and pinctrl support for SDX75 [2] which are under review.

With this current devicetree support, the IDP can boot into initramfsshell.

[1] https://lore.kernel.org/lkml/20230419133013.2563-3-quic_tdas@quicinc.com/
[2] https://lore.kernel.org/all/1684409015-25196-1-git-send-email-quic_rohiagar@quicinc.com/

Thanks,
Rohit.

Imran Shaik (1):
  arm64: dts: qcom: Add support for GCC and RPMHCC for SDX75

Rohit Agarwal (9):
  dt-bindings: arm: qcom: Document SDX75 platform and boards
  dt-bindings: firmware: scm: Add compatible for SDX75
  dt-bindings: interrupt-controller: Add SDX75 PDC compatible
  dt-bindings: arm-smmu: Add SDX75 SMMU compatible
  dt-bindings: cpufreq: cpufreq-qcom-hw: Add SDX75 compatible
  arm64: dts: qcom: Add SDX75 platform and IDP board support
  arm64: dts: qcom: Add QUPv3 UART console node for SDX75
  arm64: dts: qcom: Enable the QUPv3 UART console for SDX75
  arm64: dts: qcom: Add the support of cpufreq on SDX75

 Documentation/devicetree/bindings/arm/qcom.yaml    |   7 +
 .../bindings/cpufreq/cpufreq-qcom-hw.yaml          |   1 +
 .../devicetree/bindings/firmware/qcom,scm.yaml     |   1 +
 .../bindings/interrupt-controller/qcom,pdc.yaml    |   1 +
 .../devicetree/bindings/iommu/arm,smmu.yaml        |   1 +
 arch/arm64/boot/dts/qcom/Makefile                  |   1 +
 arch/arm64/boot/dts/qcom/sdx75-idp.dts             |  33 ++
 arch/arm64/boot/dts/qcom/sdx75.dtsi                | 647 +++++++++++++++++++++
 8 files changed, 692 insertions(+)
 create mode 100644 arch/arm64/boot/dts/qcom/sdx75-idp.dts
 create mode 100644 arch/arm64/boot/dts/qcom/sdx75.dtsi

-- 
2.7.4