[PATCH v2 3/6] arm64: zynqmp: Set qspi tx-buswidth to 4
Michal Simek
michal.simek at amd.com
Mon Jun 5 04:16:06 PDT 2023
On 5/22/23 16:59, Michal Simek wrote:
> From: Amit Kumar Mahapatra <amit.kumar-mahapatra at xilinx.com>
>
> All ZynqMP boards are setting up tx-buswidth to 1. Due to this the
> framework only issues 1-1-1 write commands to the GQSPI driver. But the
> GQSPI controller is capable of handling 1-4-4 write commands, so updated
> the tx-buswidth to 4.
> Using all 4 lines will increase the tx data transfer rate, as now the
> tx data will be transferred on four lines instead on single line.
>
> Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra at xilinx.com>
> Signed-off-by: Michal Simek <michal.simek at amd.com>
> ---
>
> Changes in v2:
> - Update commit message to skip spi-nor part - reported by Laurent
>
> arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts | 2 +-
> arch/arm64/boot/dts/xilinx/zynqmp-zcu1275-revA.dts | 2 +-
> 11 files changed, 11 insertions(+), 11 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> index c1ab1ab690df..84e18fdce775 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> @@ -124,7 +124,7 @@ spi_flash: flash at 0 { /* MT25QU512A */
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <40000000>; /* 40MHz */
> partition at 0 {
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts
> index 48d6a7202406..04079d1704f1 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zc1232-revA.dts
> @@ -44,7 +44,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts
> index e80484f9b137..3dec57cf18be 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zc1254-revA.dts
> @@ -45,7 +45,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>; /* FIXME also DUAL configuration possible */
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts
> index af3331c133ad..d9d1de5f313c 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm015-dc1.dts
> @@ -355,7 +355,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts
> index 05be71eab722..6636e76545a5 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zc1751-xm018-dc4.dts
> @@ -173,7 +173,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>; /* also DUAL configuration possible */
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> index a074d8e2b86d..8767f147cbe3 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> @@ -957,7 +957,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>; /* FIXME also DUAL configuration possible */
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts
> index 91c9b77f6b1f..e185709c0d84 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revA.dts
> @@ -444,7 +444,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts
> index 954044d9899f..7fceebd1815c 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts
> @@ -456,7 +456,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts
> index ab5e34b43642..27b2416cb6d8 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu106-revA.dts
> @@ -964,7 +964,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>; /* FIXME also DUAL configuration possible */
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts
> index f31365a14f73..6224365826d8 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu111-revA.dts
> @@ -794,7 +794,7 @@ flash at 0 {
> #address-cells = <1>;
> #size-cells = <1>;
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>; /* FIXME also DUAL configuration possible */
> spi-max-frequency = <108000000>; /* Based on DC1 spec */
> };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu1275-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu1275-revA.dts
> index e615286b8eff..c406017b0348 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu1275-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu1275-revA.dts
> @@ -47,7 +47,7 @@ &qspi {
> flash at 0 {
> compatible = "m25p80", "jedec,spi-nor";
> reg = <0x0>;
> - spi-tx-bus-width = <1>;
> + spi-tx-bus-width = <4>;
> spi-rx-bus-width = <4>;
> spi-max-frequency = <108000000>;
> };
Applied.
M
More information about the linux-arm-kernel
mailing list