[PATCH v1 00/15] Maintenance updates for Protonic Holland boards

[Shawn Guo]

On Tue, May 30, 2023 at 02:03:30PM +0200, Oleksij Rempel wrote:
> This patchset consists of several updates that address issues on
> Protonic Holland's supported i.MX6-based devices, with a particular
> focus on the USB subsystem configuration, thermal zones, and the naming
> of GPIO keys. Some of these changes include the activation of USB over-
> current detection on certain ports, the disabling of unused USB PHY
> nodes, fixing USB-related warnings, adding trip points to thermal zones
> on several devices, and renaming the 'power' key to meet the necessary
> conventions.
> 
> David Jander (1):
>   ARM: dts: imx6dl: prtvt7: Remove touchscreen inversion
> 
> Oleksij Rempel (11):
>   ARM: dts: imx6dl: lanmcu: Disable unused USB PHY nodes
>   ARM: dts: imx6dl: lanmcu: Configure over-current polarity for USB OTG
>     node
>   ARM: dts: imx6dl: Add trip points to thermal zones on several devices
>   ARM: dts: imx6dl: vicut1: Address USB related warnings
>   ARM: dts: imx6dl: alti6p: fix different USB related warnings
>   ARM: dts: imx6dl: prtmvt: fix different USB related warnings
>   ARM: dts: imx6qp: prtwd3: Enable USB over current detection on USB OTG
>     port
>   ARM: dts: imx6ul: prti6g: fix USB over-current detection on USB OTG
>     port
>   ARM: dts: imx6dl: plybas: fix USB over-current detection on USB OTG
>     port
>   ARM: dts: imx6dl: prtrvt, prtvt7, prti6q, prtwd2: fix USB related
>     warnings
>   ARM: dts: imx6qdl: vicut1: rename power to power-button
> 
> Robin van der Gracht (3):
>   ARM: dts: imx6qdl: vicut1: The sgtl5000 uses i2s not ac97
>   ARM: dts: imx6dl: prtvt7: Adjust default backlight brightness to 65
>   ARM: dts: imx6q: prtwd2: Correct iomux configuration for ENET MDIO and
>     MDC

Applied all, thanks!