[PATCH] ARM: dts: imx: Set default tuning step for imx6sx usdhc

[Xiaolei Wang]

If the tuning step is not set, the tuning step is set to 1.
For some sd cards, the following Tuning timeout will occur.

Tuning failed, falling back to fixed sampling clock

So set the default tuning step. This refers to the NXP vendor's
commit below:

https://github.com/nxp-imx/linux-imx/blob/lf-6.1.y/
arch/arm/boot/dts/imx6sx.dtsi#L1108-L1109

Fixes: 1e336aa0c025 ("mmc: sdhci-esdhc-imx: correct the tuning start tap and step setting")
Signed-off-by: Xiaolei Wang <xiaolei.wang at windriver.com>
---
 arch/arm/boot/dts/nxp/imx/imx6sx.dtsi | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi b/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi
index 3a4308666552..5bed7b411a3a 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6sx.dtsi
@@ -1010,6 +1010,8 @@ usdhc1: mmc at 2190000 {
 					 <&clks IMX6SX_CLK_USDHC1>;
 				clock-names = "ipg", "ahb", "per";
 				bus-width = <4>;
+				fsl,tuning-start-tap = <20>;
+				fsl,tuning-step= <2>;
 				status = "disabled";
 			};
 
@@ -1022,6 +1024,8 @@ usdhc2: mmc at 2194000 {
 					 <&clks IMX6SX_CLK_USDHC2>;
 				clock-names = "ipg", "ahb", "per";
 				bus-width = <4>;
+				fsl,tuning-start-tap = <20>;
+				fsl,tuning-step= <2>;
 				status = "disabled";
 			};
 
@@ -1034,6 +1038,8 @@ usdhc3: mmc at 2198000 {
 					 <&clks IMX6SX_CLK_USDHC3>;
 				clock-names = "ipg", "ahb", "per";
 				bus-width = <4>;
+				fsl,tuning-start-tap = <20>;
+				fsl,tuning-step= <2>;
 				status = "disabled";
 			};
 
-- 
2.25.1