[PATCH 0/5] arm: dts: mt7623: relocate gmacs, mt7530 switch, and mux phy

[Matthias Brugger]

On 20/01/2023 21:53, Arınç ÜNAL wrote:
> Yeia sou!
> 

γεια σας!

Whole series applied, thanks!

> I initially just wanted to submit the phy muxing patch for BPI-R2 but after
> looking around the bindings, I decided to do a bit of a cleanup.
> 
> The main takeaway of the cleanup is that the MT7530 switch is actually a
> part of the multi-chip module on the MT7623AI SoC. I'm moving the bindings
> for this switch to mt7623a.dtsi so they don't need to be defined on every
> device with this SoC. This should ease it up for supporting more devices
> with MT7623AI SoC on mainline.
> 
> I don't know if there's a pin wired for interrupt. The switch is going to
> work with polling for the time being. Folks from MediaTek, feel free to
> fill me in on this.
> 
> I've tested phy muxing on my BPI-R2. DTs compile fine.
> 
> Arınç ÜNAL (5):
>    arm: dts: mt7623: add gmacs to mt7623.dtsi
>    arm: dts: mt7623: add mt7530 switch to mt7623a.dtsi
>    arm: dts: mt7623: change mt7530 switch address
>    arm: dts: mt7623: mux phy0 on Bananapi BPI-R2
>    arm: dts: mt7623: enable flow control on port at 6
> 
>   arch/arm/boot/dts/mt7623.dtsi                 | 14 ++++
>   arch/arm/boot/dts/mt7623a-rfb-emmc.dts        | 86 ++++++----------------
>   arch/arm/boot/dts/mt7623a-rfb-nand.dts        | 86 ++++++----------------
>   arch/arm/boot/dts/mt7623a.dtsi                | 74 +++++++++++++++++++
>   arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts | 22 +++---
>   arch/arm/boot/dts/mt7623n-rfb-emmc.dts        | 13 ++--
>   6 files changed, 147 insertions(+), 148 deletions(-)
> 
>