[PATCH v2 1/4] spi: cadence-quadspi: Reset CMD_CTRL Reg on cmd r/w completion

[Dhruva Gole]

If one leaves the CQSPI_REG_CMDCTRL in an unclean state this may cause
issues in future command reads. This issue came to light when some flash
reads in STIG mode were coming back dirty.

Signed-off-by: Dhruva Gole <d-gole at ti.com>
---
 drivers/spi/spi-cadence-quadspi.c | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index 676313e1bdad..6030da942c6e 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -549,6 +549,9 @@ static int cqspi_command_read(struct cqspi_flash_pdata *f_pdata,
 		memcpy(rxbuf, &reg, read_len);
 	}

+	/* Reset CMD_CTRL Reg once command read completes */
+	writel(0, reg_base + CQSPI_REG_CMDCTRL);
+
 	return 0;
 }

@@ -613,7 +616,12 @@ static int cqspi_command_write(struct cqspi_flash_pdata *f_pdata,
 		}
 	}

-	return cqspi_exec_flash_cmd(cqspi, reg);
+	ret = cqspi_exec_flash_cmd(cqspi, reg);
+
+	/* Reset CMD_CTRL Reg once command write completes */
+	writel(0, reg_base + CQSPI_REG_CMDCTRL);
+
+	return ret;
 }

 static int cqspi_read_setup(struct cqspi_flash_pdata *f_pdata,
--
2.25.1