[PATCH 6/7] arm64: dts: Add ipq9574 SoC and AL02 board support

[Devi Priya]

On 1/24/2023 3:16 PM, Konrad Dybcio wrote:
> 
> 
> On 24.01.2023 08:19, Devi Priya wrote:
>>
>>
>> On 1/13/2023 7:50 PM, Krzysztof Kozlowski wrote:
>>> On 13/01/2023 14:29, Devi Priya wrote:
>>>>>> +
>>>>>> +    soc: soc at 0 {
>>>>>> +        #address-cells = <1>;
>>>>>> +        #size-cells = <1>;
>>>>>> +        ranges = <0 0 0 0xffffffff>;
>>>>>> +        compatible = "simple-bus";
>>>>>> +
>>>>>> +        tlmm: pinctrl at 1000000 {
>>>>>> +            compatible = "qcom,ipq9574-tlmm";
>>>>>> +            reg = <0x01000000 0x300000>;
>>>>>> +            interrupts = <GIC_SPI 208 IRQ_TYPE_LEVEL_HIGH>;
>>>>>> +            gpio-controller;
>>>>>> +            #gpio-cells = <2>;
>>>>>> +            gpio-ranges = <&tlmm 0 0 65>;
>>>>>> +            gpio-reserved-ranges = <59 1>;
>>>>>
>>>>> Hm, why reserved ranges are in SoC?
>>>> As the gpio is forbidden on all ipq9574 boards, we have added it in SoC
>>>
>>> Why it is forbidden on all boards? I guess it depends on the firmware
>>> and this can differ, can't it?
>>>
>> This GPIO is protected and used by the TZ firmware and is forbidden on all the boards & firmware
> If it's protected on *all* boards and *all* firmwares (for any
> good reason that you probably have internally), perhaps it
> would be better to describe it in the .c driver.. wdyt?
> 
Sure, okay. Will add the gpio to reserved_gpios entry in the pinctrl driver
> Konrad
>>> Best regards,
>>> Krzysztof
>>>
>> Regards,
>> Devi Priya