[PATCH v6 5/6] soc: mediatek: mutex: Add mtk_mutex_set_mod support to set MOD1

[Moudy Ho]

From: "Roy-CW.Yeh" <roy-cw.yeh at mediatek.com>

Add mtk_mutex_set_mod support to set MOD1

Signed-off-by: Roy-CW.Yeh <roy-cw.yeh at mediatek.com>
Signed-off-by: Moudy Ho <moudy.ho at mediatek.com>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>
---
 drivers/soc/mediatek/mtk-mutex.c | 33 +++++++++++++++++++++++++-------
 1 file changed, 26 insertions(+), 7 deletions(-)

diff --git a/drivers/soc/mediatek/mtk-mutex.c b/drivers/soc/mediatek/mtk-mutex.c
index 582d4b04e353..d4124800c886 100644
--- a/drivers/soc/mediatek/mtk-mutex.c
+++ b/drivers/soc/mediatek/mtk-mutex.c
@@ -23,6 +23,7 @@
 #define DISP_REG_MUTEX(n)			(0x24 + 0x20 * (n))
 #define DISP_REG_MUTEX_RST(n)			(0x28 + 0x20 * (n))
 #define DISP_REG_MUTEX_MOD(mutex_mod_reg, n)	(mutex_mod_reg + 0x20 * (n))
+#define DISP_REG_MUTEX_MOD1(mutex_mod_reg, n)	((mutex_mod_reg) + 0x20 * (n) + 0x4)
 #define DISP_REG_MUTEX_SOF(mutex_sof_reg, n)	(mutex_sof_reg + 0x20 * (n))
 #define DISP_REG_MUTEX_MOD2(n)			(0x34 + 0x20 * (n))
 
@@ -791,7 +792,7 @@ int mtk_mutex_write_mod(struct mtk_mutex *mutex,
 	struct mtk_mutex_ctx *mtx = container_of(mutex, struct mtk_mutex_ctx,
 						 mutex[mutex->id]);
 	unsigned int reg;
-	unsigned int offset;
+	u32 reg_offset, id_offset = 0;
 
 	WARN_ON(&mtx->mutex[mutex->id] != mutex);
 
@@ -801,16 +802,34 @@ int mtk_mutex_write_mod(struct mtk_mutex *mutex,
 		return -EINVAL;
 	}
 
-	offset = DISP_REG_MUTEX_MOD(mtx->data->mutex_mod_reg,
-				    mutex->id);
-	reg = readl_relaxed(mtx->regs + offset);
+	/*
+	 * Some SoCs may have multiple MUTEX_MOD registers as more than 32 mods
+	 * are present, hence requiring multiple 32-bits registers.
+	 *
+	 * The mutex_table_mod fully represents that by defining the number of
+	 * the mod sequentially, later used as a bit number, which can be more
+	 * than 0..31.
+	 *
+	 * In order to retain compatibility with older SoCs, we perform R/W on
+	 * the single 32 bits registers, but this requires us to translate the
+	 * mutex ID bit accordingly.
+	 */
+	if (mtx->data->mutex_table_mod[idx] < 32) {
+		reg_offset = DISP_REG_MUTEX_MOD(mtx->data->mutex_mod_reg,
+						mutex->id);
+	} else {
+		reg_offset = DISP_REG_MUTEX_MOD1(mtx->data->mutex_mod_reg,
+						 mutex->id);
+		id_offset = 32;
+	}
 
+	reg = readl_relaxed(mtx->regs + reg_offset);
 	if (clear)
-		reg &= ~BIT(mtx->data->mutex_table_mod[idx]);
+		reg &= ~BIT(mtx->data->mutex_table_mod[idx] - id_offset);
 	else
-		reg |= BIT(mtx->data->mutex_table_mod[idx]);
+		reg |= BIT(mtx->data->mutex_table_mod[idx] - id_offset);
 
-	writel_relaxed(reg, mtx->regs + offset);
+	writel_relaxed(reg, mtx->regs + reg_offset);
 
 	return 0;
 }
-- 
2.18.0