[PATCH v4 0/3] Improve K3-am625-sk support (USB, MMC)

[Sjoerd Simons]

This series picks up a few patches from the TI BSP tree that
unfortunately didn't make it upstream thusfar.

The first patch improve SD card compatibility (allowing U1 class cards
to be used), the remaining ones add USB support.

The type-c connector isn't entirely modelled with these changes as
it goes through a TPS6598 PD controller. Unfortunately the dtb bindings
for that currently require an irq line, which is not connected on E1 and
E2 version boards. The patchese to support this setup unfortunately didn't land
yet[0].. As such the last patch ignored the PD controller and simply
configures usb0 as periphal only rather then mode switch capable, which
at least gives some basic usability of that USB port.

0: https://lore.kernel.org/lkml/f714ee55-ef47-317d-81b9-57020dda064b@ti.com/T/

Changes in v4:
- Disable new usbss nodes by default in the dtsi and enable in the dts
- Drop unneeded disabled nodes in board dts

Changes in v3:
- Rebased against current ti-next aka 6.2-rc1
- Add Martyn's tested-by

Changes in v2:
- Rebase against linux-next 20221220

Aswath Govindraju (2):
  arm64: dts: ti: k3-am62-main: Add support for USB
  arm64: dts: ti: k3-am625-sk: Add support for USB

Nitin Yadav (1):
  arm64: dts: ti: k3-am62-main: Update OTAP and ITAP delay select

 arch/arm64/boot/dts/ti/k3-am62-main.dtsi | 92 ++++++++++++++++++------
 arch/arm64/boot/dts/ti/k3-am625-sk.dts   | 27 +++++++
 2 files changed, 97 insertions(+), 22 deletions(-)

-- 
2.39.0