[PATCH v2 3/3] drm/panel: boe-tv101wum-nl6: Fine tune the panel power sequence

AngeloGioacchino Del Regno angelogioacchino.delregno at collabora.com
Tue Jan 10 01:22:44 PST 2023


Il 10/01/23 06:54, xinlei.lee at mediatek.com ha scritto:
> From: Xinlei Lee <xinlei.lee at mediatek.com>
> 
> For "boe,tv105wum-nw0" this special panel, it is stipulated in the
> panel spec that MIPI needs to keep the LP11 state before the
> lcm_reset pin is pulled high.
> 
> Signed-off-by: Xinlei Lee <xinlei.lee at mediatek.com>
> ---
>   drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c | 6 ++++++
>   1 file changed, 6 insertions(+)
> 
> diff --git a/drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c b/drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c
> index f0093035f1ff..67df61de64ae 100644
> --- a/drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c
> +++ b/drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c
> @@ -36,6 +36,7 @@ struct panel_desc {
>   	const struct panel_init_cmd *init_cmds;
>   	unsigned int lanes;
>   	bool discharge_on_disable;
> +	bool lp11_before_reset;
>   };
>   
>   struct boe_panel {
> @@ -1261,6 +1262,10 @@ static int boe_panel_prepare(struct drm_panel *panel)
>   
>   	usleep_range(10000, 11000);
>   
> +	if (boe->desc->lp11_before_reset) {
> +		mipi_dsi_dcs_nop(boe->dsi);

NOP will never reach the driveric if it is in reset, which should apparently be
the state of it at that point in code.

I guess that you wanted to do that after LCM reset and before sending init cmds.

Regards,
Angelo




More information about the linux-arm-kernel mailing list