[PATCH V4 0/3] AM68 SK: Add initial support

[Sinthu Raja]

From: Sinthu Raja <sinthu.raja at ti.com>

Hi All,
Respinning this series after rebasing to 6.2.rc1.
This series of patches add support for AM68 Starter kit(SK). AM68 SK
is a low cost, small form factor board designed for TI’s AM68 SoC.

Refer below link to AM68 Technical Reference Manual for further details: 
http://www.ti.com/lit/pdf/spruj28

Design files can be referrred from https://www.ti.com/lit/zip/SPRR463

Changes in V4:
=============
Repost after rebasing to 6.2 rc1

Changes in  V3:
==============
Addressed all the review comments and the changes are captured in separate patches.
 - Removed the unused nodes that are disabled by default.
 - Updated the gpio regulator node: gpio-regulator-tlv to "regulator-tlv".

V1: https://lore.kernel.org/linux-arm-kernel/20221018123849.23695-1-sinthu.raja@ti.com/t/#mbe43b02221733bb6eb06b203359e90ec08406afc
V2: https://lore.kernel.org/lkml/20221107123852.8063-1-sinthu.raja@ti.com/
V3: https://lore.kernel.org/linux-arm-kernel/20221115154832.19759-1-sinthu.raja@ti.com/

Sinthu Raja (3):
  dt-bindings: arm: ti: Add binding for AM68 SK
  arm64: dts: ti: Add initial support for AM68 SK System on Module
  arm64: dts: ti: k3-am68-sk: Add support for AM68 SK base board

 .../devicetree/bindings/arm/ti/k3.yaml        |   1 +
 arch/arm64/boot/dts/ti/Makefile               |   2 +
 .../boot/dts/ti/k3-am68-sk-base-board.dts     | 335 ++++++++++++++++++
 arch/arm64/boot/dts/ti/k3-am68-sk-som.dtsi    |  31 ++
 4 files changed, 369 insertions(+)
 create mode 100644 arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
 create mode 100644 arch/arm64/boot/dts/ti/k3-am68-sk-som.dtsi

-- 
2.36.1