[PATCH v2 5/5] arm64: dts: imx8mm-tqma8mqml: Fix temperature sensor compatible

[Alexander Stein]

Use the correct compatible 'nxp,se97b' as it is an SE97BTP chip.
While at it, fix the node name according to device tree spec
recommendations. The EEPROM is a separate node anyway.

Signed-off-by: Alexander Stein <alexander.stein at ew.tq-group.com>
---
Changes in v2:
* Split into arm64-only series

 arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
index 88d89cd46c74..b4466a26d838 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
@@ -87,8 +87,8 @@ &i2c1 {
 	sda-gpios = <&gpio5 15 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 	status = "okay";
 
-	sensor0: temperature-sensor-eeprom at 1b {
-		compatible = "nxp,se97", "jedec,jc-42.4-temp";
+	sensor0: temperature-sensor at 1b {
+		compatible = "nxp,se97b", "jedec,jc-42.4-temp";
 		reg = <0x1b>;
 	};
 
-- 
2.34.1