(subset) [PATCH v3 0/9] fix reset line polarity for Goodix touchscreen controllers

[Quentin Schulz]

Hi all,

On 1/16/23 13:37, Quentin Schulz wrote:
> Hi Bjorn, all,
> 
> On 1/10/23 17:17, Bjorn Andersson wrote:
>> On Mon, 5 Dec 2022 14:40:29 +0100, Quentin Schulz wrote:
>>> From: Quentin Schulz <quentin.schulz at theobroma-systems.com>
>>>
>>> The Goodix touchscreen controller has a reset line active low. It 
>>> happens to
>>> also be used to configure its i2c address at runtime. If the reset 
>>> line is
>>> incorrectly asserted, the address will be wrongly configured. This 
>>> cost me a few
>>> hours, trying to figure out why the touchscreen wouldn't work.
>>>
>>> [...]
>>
>> Applied, thanks!
>>
>> [8/9] arm64: dts: qcom: msm8998-fxtec: fix touchscreen reset GPIO 
>> polarity
>>        commit: 8a0721dae68fdb4534e220fc9faae7a0ef2f3785
>>
> 
> Thank you for the merge, however I think there could be some issue here.
> 
> This requires the patches 1, 2 and 3 all modifying the input driver in 
> order to not introduce a regression.
> 
> I mistakenly removed the RFC tag and seemingly didn't make it clear 
> enough that I had some question on how to properly merge this patch 
> series, c.f. "Do we also make this patch series only one patchset since 
> the DT patches depend
> on the driver patch and vice-versa? In which tree would this go?" in the 
> cover letter.
> 
> So please, how do we go on with the rest of the patch series? Should I 
> submit a v4 which would be only one patch with DT and input changes all 
> at once and Bjorn reverts the patch they had just merged?
> 
> @Dmitry, since you would have to merge at least patches 1 to 3 in your 
> tree (I assume), would you be willing to take the DT patches at the same 
> time through your tree too? Are the appropriate device DT maintainers OK 
> with this?
> 

Ping.

Cheers,
Quentin