[PATCH v3 00/14] media: rkisp1: Add support for i.MX8MP
Nicolas Dufresne
nicolas at ndufresne.ca
Fri Feb 24 10:24:48 PST 2023
Hi Adam,
Le jeudi 23 février 2023 à 10:10 -0600, Adam Ford a écrit :
> On Thu, Feb 23, 2023 at 8:26 AM Laurent Pinchart
> <laurent.pinchart at ideasonboard.com> wrote:
> >
> > Hi Adam,
> >
> > On Wed, Feb 22, 2023 at 05:39:30PM -0600, Adam Ford wrote:
> > > On Fri, Nov 18, 2022 at 3:44 AM Paul Elder wrote:
> > > >
> > > > This series depends on v3 of "dt-bindings: media: Add macros for video
> > > > interface bus types" [1].
> > > >
> > > > This series extends the rkisp1 driver to support the ISP found in the
> > > > NXP i.MX8MP SoC.
> > > >
> > > > The ISP IP cores in the Rockchip RK3399 (known as the "Rockchip ISP1")
> > > > and in the NXP i.MX8MP have the same origin, and have slightly diverged
> > > > over time as they are now independently developed (afaik) by Rockchip
> > > > and VeriSilicon. The latter is marketed under the name "ISP8000Nano",
> > > > and is close enough to the RK3399 ISP that it can easily be supported by
> > > > the same driver.
> > > >
> > > > The last two patches add support for UYVY output format, which can be
> > > > implemented on the ISP version in the i.MX8MP but not in the one in the
> > > > RK3399.
> > > >
> > > > This version of the series specifically has been tested on a Polyhex
> > > > Debix model A with an imx219 (Raspberry Pi cam v2).
> > > >
> > > > [1] https://lore.kernel.org/linux-media/20220615221410.27459-2-laurent.pinchart@ideasonboard.com/
> > > >
> > > > Laurent Pinchart (3):
> > > > dt-bindings: media: rkisp1: Add i.MX8MP ISP example
> > > > media: rkisp1: Add and use rkisp1_has_feature() macro
> > > > media: rkisp1: Configure gasket on i.MX8MP
> > > >
> > > > Paul Elder (11):
> > > > dt-bindings: media: rkisp1: Add i.MX8MP ISP to compatible
> > > > media: rkisp1: Add match data for i.MX8MP ISP
> > > > media: rkisp1: Add and set registers for crop for i.MX8MP
> > > > media: rkisp1: Add and set registers for output size config on i.MX8MP
> > > > media: rkisp1: Add i.MX8MP-specific registers for MI and resizer
> > > > media: rkisp1: Shift DMA buffer addresses on i.MX8MP
> > > > media: rkisp1: Add register definitions for the test pattern generator
> > > > media: rkisp1: Fix RSZ_CTRL bits for i.MX8MP
> > > > media: rkisp1: Support devices without self path
> > > > media: rkisp1: Add YC swap capability
> > > > media: rkisp1: Add UYVY as an output format
> > >
> > > Paul / Laurent,
> > >
> > > I noticed an unexpected behaviour on the imx8mp.
> > >
> > > If I setup my pipeline for 640x480, it works just fine using an imx219
> > > camera configured for SRGGB10_1X10.
> > >
> > > However, when I try to configure the pipeline to use the same camera
> > > at 1920x1080 (no resizing), the ISP source keeps defaulting to 640x480
> > >
> > > Media device information
> > > ------------------------
> > > driver rkisp1
> > > model rkisp1
> > > serial
> > > bus info platform:rkisp1
> > > hw revision 0xe
> > > driver version 6.2.0
> > >
> > > Device topology
> > > - entity 1: rkisp1_isp (4 pads, 4 links)
> > > type V4L2 subdev subtype Unknown flags 0
> > > device node name /dev/v4l-subdev0
> > > pad0: Sink [fmt:SRGGB10_1X10/1920x1080 field:none colorspace:raw xfer:none ycbcr:601 quantization:full-range crop.bounds:(0,0)/1920x1080 crop:(0,0)/640x480]
> >
> > You're cropping the image to 640x480 here. You need to set the crop
> > rectangle to 1920x1080.
> >
> > As Jacopo mentioned, I wouldn't recommend exercising the ISP directly.
> > Not only do you need to setup the pipeline, but you would also need to
> > implement all the imaging algorithms in userspace. libcamera will do all
> > this for you.
>
> I'll give that a try. My current employer has a v4l2src requirement,
> but I can likely make an argument to switch to libcamera. I didn't
> catch the cropping part. Thanks for that.
I'd hope you can transparently replace v4l2src with libcamerasrc, the plugins
currently lives inside the libcamera project. If not, I'd really like to know
why. We can work together on adding missing controls (this is something I'm
starting on soon).
regards,
Nicolas
>
> adam
> >
> > > <- "csis-32e40000.csi":1 [ENABLED]
> > > pad1: Sink [fmt:unknown/0x0 field:none]
> > > <- "rkisp1_params":0 [ENABLED,IMMUTABLE]
> > > pad2: Source [fmt:YUYV8_2X8/640x480 field:none colorspace:raw xfer:none ycbcr:601 quantization:lim-range crop.bounds:(0,0)/640x480 crop:(0,0)/640x480]
> > > -> "rkisp1_resizer_mainpath":0 [ENABLED]
> > > pad3: Source [fmt:unknown/0x0 field:none]
> > > -> "rkisp1_stats":0 [ENABLED,IMMUTABLE]
> > >
> > > - entity 6: rkisp1_resizer_mainpath (2 pads, 2 links)
> > > type V4L2 subdev subtype Unknown flags 0
> > > device node name /dev/v4l-subdev1
> > > pad0: Sink [fmt:YUYV8_2X8/1920x1080 field:none colorspace:srgb xfer:srgb ycbcr:601 quantization:lim-range crop.bounds:(0,0)/1920x1080 crop:(0,0)/640x480]
> > > <- "rkisp1_isp":2 [ENABLED]
> > > pad1: Source [fmt:YUYV8_2X8/1920x1080 field:none colorspace:srgb xfer:srgb ycbcr:601 quantization:lim-range]
> > > -> "rkisp1_mainpath":0 [ENABLED,IMMUTABLE]
> > >
> > > - entity 9: rkisp1_mainpath (1 pad, 1 link)
> > > type Node subtype V4L flags 0
> > > device node name /dev/video0
> > > pad0: Sink
> > > <- "rkisp1_resizer_mainpath":1 [ENABLED,IMMUTABLE]
> > >
> > > - entity 13: rkisp1_stats (1 pad, 1 link)
> > > type Node subtype V4L flags 0
> > > device node name /dev/video1
> > > pad0: Sink
> > > <- "rkisp1_isp":3 [ENABLED,IMMUTABLE]
> > >
> > > - entity 17: rkisp1_params (1 pad, 1 link)
> > > type Node subtype V4L flags 0
> > > device node name /dev/video2
> > > pad0: Source
> > > -> "rkisp1_isp":1 [ENABLED,IMMUTABLE]
> > >
> > > - entity 29: csis-32e40000.csi (2 pads, 2 links)
> > > type V4L2 subdev subtype Unknown flags 0
> > > device node name /dev/v4l-subdev2
> > > pad0: Sink [fmt:SRGGB10_1X10/1920x1080 field:none colorspace:srgb xfer:srgb ycbcr:601 quantization:full-range]
> > > <- "imx219 1-0010":0 [ENABLED]
> > > pad1: Source [fmt:SRGGB10_1X10/1920x1080 field:none colorspace:srgb xfer:srgb ycbcr:601 quantization:full-range]
> > > -> "rkisp1_isp":0 [ENABLED]
> > >
> > > - entity 34: imx219 1-0010 (1 pad, 1 link)
> > > type V4L2 subdev subtype Sensor flags 0
> > > device node name /dev/v4l-subdev3
> > > pad0: Source [fmt:SRGGB10_1X10/1920x1080 field:none colorspace:srgb xfer:srgb ycbcr:601 quantization:full-range crop.bounds:(8,8)/3280x2464 crop:(688,700)/1920x1080]
> > > -> "csis-32e40000.csi":0 [ENABLED]
> > >
> > > It's at this point that everything except the ISP source is 1920x1080.
> > >
> > > When I try to set the ISP sink to 1080, it ends up being 640x480 and
> > > the resizer sink is also changed to 640x480
> > >
> > > root at beacon-imx8mp-kit:~# media-ctl -v -V "'rkisp1_isp':2
> > > [fmt:YUYV8_2X8/1920x1080 field:none]"
> > > Opening media device /dev/media0
> > > Enumerating entities
> > > looking up device: 81:3
> > > looking up device: 81:4
> > > looking up device: 81:0
> > > looking up device: 81:1
> > > looking up device: 81:2
> > > looking up device: 81:5
> > > looking up device: 81:6
> > > Found 7 entities
> > > Enumerating pads and links
> > > Setting up format YUYV8_2X8 1920x1080 on pad rkisp1_isp/2
> > > Format set: YUYV8_2X8 640x480
> > > Setting up format YUYV8_2X8 640x480 on pad rkisp1_resizer_mainpath/0
> > > Format set: YUYV8_2X8 640x480
> > >
> > >
> > > It's my understanding that the ISP should be able to handle 1920x1080,
> > > and the resizer sink should match the ISP source.
> > >
> > > With the pipeline improperly setup, the capture fails.
> > >
> > > > .../bindings/media/rockchip-isp1.yaml | 79 ++++++++++-
> > > > .../platform/rockchip/rkisp1/rkisp1-capture.c | 102 +++++++++++---
> > > > .../platform/rockchip/rkisp1/rkisp1-common.h | 32 +++++
> > > > .../platform/rockchip/rkisp1/rkisp1-debug.c | 14 +-
> > > > .../platform/rockchip/rkisp1/rkisp1-dev.c | 67 +++++++--
> > > > .../platform/rockchip/rkisp1/rkisp1-isp.c | 128 +++++++++++++++++-
> > > > .../platform/rockchip/rkisp1/rkisp1-regs.h | 90 ++++++++++++
> > > > .../platform/rockchip/rkisp1/rkisp1-resizer.c | 35 ++++-
> > > > include/uapi/linux/rkisp1-config.h | 2 +
> > > > 9 files changed, 509 insertions(+), 40 deletions(-)
> >
> > --
> > Regards,
> >
> > Laurent Pinchart
More information about the linux-arm-kernel
mailing list