[PATCH net-next v10 00/12] net: ethernet: mtk_eth_soc: various enhancements
Paolo Abeni
pabeni at redhat.com
Tue Feb 21 03:59:25 PST 2023
On Tue, 2023-02-21 at 11:39 +0000, Daniel Golle wrote:
> This series brings a variety of fixes and enhancements for mtk_eth_soc,
> adds support for the MT7981 SoC and facilitates sharing the SGMII PCS
> code between mtk_eth_soc and mt7530.
>
> Note that this series depends on commit 697c3892d825
> ("regmap: apply reg_base and reg_downshift for single register ops") to
> not break mt7530 pcs register access.
>
> The whole series has been tested on MT7622+MT7531 (BPi-R64),
> MT7623+MT7530 (BPi-R2) and MT7981+GPY211 (GL.iNet GL-MT3000).
>
> Changes since v9:
> * fix path in mediatek,sgmiisys dt-binding
>
> Changes since v8:
> * move mediatek,sgmiisys dt-bindings to correct net/pcs folder
> * rebase on top of net-next/main so series applies cleanly again
>
> Changes since v7:
> * move mediatek,sgmiisys.yaml to more appropriate folder
> * don't include <linux/phylink.h> twice in PCS driver, sort includes
>
> Changes since v6:
> * label MAC MCR bit 12 in 08/12, MediaTek replied explaining its function
>
> Changes since v5:
> * drop dev pointer also from struct mtk_sgmii, pass it as function
> parameter instead
> * address comments left for dt-bindings
> * minor improvements to commit messages
>
> Changes since v4:
> * remove unused dev pointer in struct pcs_mtk_lynxi
> * squash link timer check into correct follow-up patch
>
> Changes since v3:
> * remove unused #define's
> * use BMCR_* instead of #define'ing our own constants
> * return before changing registers in case of invalid link timer
>
> Changes since v2:
> * improve dt-bindings, convert sgmisys bindings to dt-schema yaml
> * fix typo
>
> Changes since v1:
> * apply reverse xmas tree everywhere
> * improve commit descriptions
> * add dt binding documentation
> * various small changes addressing all comments received for v1
>
>
> Daniel Golle (12):
> net: ethernet: mtk_eth_soc: add support for MT7981 SoC
> dt-bindings: net: mediatek,net: add mt7981-eth binding
> dt-bindings: arm: mediatek: sgmiisys: Convert to DT schema
> dt-bindings: arm: mediatek: sgmiisys: add MT7981 SoC
> net: ethernet: mtk_eth_soc: set MDIO bus clock frequency
> net: ethernet: mtk_eth_soc: reset PCS state
> net: ethernet: mtk_eth_soc: only write values if needed
> net: ethernet: mtk_eth_soc: fix RX data corruption issue
> net: ethernet: mtk_eth_soc: ppe: add support for flow accounting
> net: pcs: add driver for MediaTek SGMII PCS
> net: ethernet: mtk_eth_soc: switch to external PCS driver
> net: dsa: mt7530: use external PCS driver
>
> .../arm/mediatek/mediatek,sgmiisys.txt | 25 --
> .../devicetree/bindings/net/mediatek,net.yaml | 52 ++-
> .../bindings/net/pcs/mediatek,sgmiisys.yaml | 55 ++++
> MAINTAINERS | 7 +
> drivers/net/dsa/Kconfig | 1 +
> drivers/net/dsa/mt7530.c | 277 ++++------------
> drivers/net/dsa/mt7530.h | 47 +--
> drivers/net/ethernet/mediatek/Kconfig | 2 +
> drivers/net/ethernet/mediatek/mtk_eth_path.c | 14 +-
> drivers/net/ethernet/mediatek/mtk_eth_soc.c | 67 +++-
> drivers/net/ethernet/mediatek/mtk_eth_soc.h | 105 +++---
> drivers/net/ethernet/mediatek/mtk_ppe.c | 114 ++++++-
> drivers/net/ethernet/mediatek/mtk_ppe.h | 25 +-
> .../net/ethernet/mediatek/mtk_ppe_debugfs.c | 9 +-
> .../net/ethernet/mediatek/mtk_ppe_offload.c | 8 +
> drivers/net/ethernet/mediatek/mtk_ppe_regs.h | 14 +
> drivers/net/ethernet/mediatek/mtk_sgmii.c | 192 ++---------
> drivers/net/pcs/Kconfig | 7 +
> drivers/net/pcs/Makefile | 1 +
> drivers/net/pcs/pcs-mtk-lynxi.c | 302 ++++++++++++++++++
> include/linux/pcs/pcs-mtk-lynxi.h | 13 +
> 21 files changed, 801 insertions(+), 536 deletions(-)
> delete mode 100644 Documentation/devicetree/bindings/arm/mediatek/mediatek,sgmiisys.txt
> create mode 100644 Documentation/devicetree/bindings/net/pcs/mediatek,sgmiisys.yaml
> create mode 100644 drivers/net/pcs/pcs-mtk-lynxi.c
> create mode 100644 include/linux/pcs/pcs-mtk-lynxi.h
>
>
> base-commit: 3fcdf2dfefb6313ea0395519d1784808c0b6559b
# Form letter - net-next is closed
The merge window for v6.3 has begun and therefore net-next is closed
for new drivers, features, code refactoring and optimizations.
We are currently accepting bug fixes only.
Please repost when net-next reopens after Mar 6th.
RFC patches sent for review only are obviously welcome at any time.
More information about the linux-arm-kernel
mailing list