[PATCH 2/4] arm64: dts: qcom: sc8280xp-crd: Introduce pmic_glink

[Bjorn Andersson]

On Wed, Feb 08, 2023 at 05:40:44PM +0100, Konrad Dybcio wrote:
> On 8.02.2023 16:57, Bjorn Andersson wrote:
> > On Wed, Feb 08, 2023 at 09:14:46AM +0100, Konrad Dybcio wrote:
> >> On 8.02.2023 04:46, Bjorn Andersson wrote:
[..]
> >>>  &usb_0_dwc3 {
> >>> -	/* TODO: Define USB-C connector properly */
> >>>  	dr_mode = "host";
> >>> +
> >>> +	port {
> >>> +		usb_0_role_switch: endpoint {
> >>> +			remote-endpoint = <&pmic_glink_con0_hs>;
> >>> +		};
> >> This should be defined in the SoC DTSI, it's a standard dwc3 binding
> >> with usb HS / SS / SBU ports. Especially since we can feed the endpoint
> >> from any device now, as pmic-glink should work everywhere.
> >>
> > 
> > The sa8295p/sa8540p boards, derived from sc8280xp does not implement
> > pmic_glink, so it seems moving this to the soc.dtsi would be messy.
> > 
> >> Or /omit-if-no-ref/, I suppose.
> >>
> > 
> > Or you're saying I should put the skeleton of the port definition in the
> > soc.dtsi and then fill it out the remote-endpoint here; and mark it
> > omit-if-no-ref to avoid binding warnings?
> I thought omit-if-no-ref actually omits the node before resolving phandles
> that it references, but it seems to not be the case.. Still, we can define
> the ports in the SoC DTSI and assign endpoints per-device (like we do with
> DSI for example).
> 

You mean move the lines:

port {
	usb_0_role_switch: endpoint {
	};
};

to sc8280xp.dtsi and then do:

&usb_0_role_switch {
	remote-endpoint = <&pmic_glink_con0_hs>;
};

here?

Regards,
Bjorn