[PATCH] soc: sunxi: select CONFIG_PM

[Randy Dunlap]

On 2/4/23 02:38, Arnd Bergmann wrote:
> On Sat, Feb 4, 2023, at 08:47, Randy Dunlap wrote:
>> On 1/30/23 05:04, Arnd Bergmann wrote:
>>
>> Apparently sparc32 does not support PM (arch/sparc/Kconfig):
>>
>> if SPARC64
>> source "kernel/power/Kconfig"
>> endif
>>
>> so I think that SUN20I_PPU should also depend on !SPARC32.
>> Does that make sense?
> 
> I would suggest working around this in arch/sparc/ instead
> of every driver that uses 'select PM', perhaps something like
> 
> --- a/arch/sparc/Kconfig
> +++ b/arch/sparc/Kconfig
> @@ -283,7 +283,7 @@ config ARCH_FORCE_MAX_ORDER
>           This config option is actually maximum order plus one. For example,
>           a value of 13 means that the largest free memory block is 2^12 pages.
>  
> -if SPARC64
> +if SPARC64 || COMPILE_TEST
>  source "kernel/power/Kconfig"
>  endif
>

That looks good. Thanks.

> The issue does not happen anywhere else, as it's fine if
> kernel/power/Kconfig is not included at all. I'm also not too
> worried about random sparc32 configs since it's pretty much impossible
> to build a sparc32 allmodconfig or randconfig, with all the other
> bugs that runs into.

OK/ack.

-- 
~Randy