[PATCH 1/1] net: mdio: mux-bcm-iproc: Use alignment helpers and SZ_4K

[Ilpo Järvinen]

Instead of open coding, use IS_ALIGNED() and ALIGN_DOWN() when dealing
with alignment. Replace also literals with SZ_4K.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen at linux.intel.com>
---
 drivers/net/mdio/mdio-mux-bcm-iproc.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/net/mdio/mdio-mux-bcm-iproc.c b/drivers/net/mdio/mdio-mux-bcm-iproc.c
index a750bd4c77a0..1ce7d67ba72e 100644
--- a/drivers/net/mdio/mdio-mux-bcm-iproc.c
+++ b/drivers/net/mdio/mdio-mux-bcm-iproc.c
@@ -2,6 +2,7 @@
 /*
  * Copyright 2016 Broadcom
  */
+#include <linux/align.h>
 #include <linux/clk.h>
 #include <linux/delay.h>
 #include <linux/device.h>
@@ -11,6 +12,7 @@
 #include <linux/of_mdio.h>
 #include <linux/phy.h>
 #include <linux/platform_device.h>
+#include <linux/sizes.h>
 
 #define MDIO_RATE_ADJ_EXT_OFFSET	0x000
 #define MDIO_RATE_ADJ_INT_OFFSET	0x004
@@ -220,12 +222,12 @@ static int mdio_mux_iproc_probe(struct platform_device *pdev)
 	md->base = devm_platform_get_and_ioremap_resource(pdev, 0, &res);
 	if (IS_ERR(md->base))
 		return PTR_ERR(md->base);
-	if (res->start & 0xfff) {
+	if (!IS_ALIGNED(res->start, SZ_4K)) {
 		/* For backward compatibility in case the
 		 * base address is specified with an offset.
 		 */
 		dev_info(&pdev->dev, "fix base address in dt-blob\n");
-		res->start &= ~0xfff;
+		res->start = ALIGN_DOWN(res->start, SZ_4K);
 		res->end = res->start + MDIO_REG_ADDR_SPACE_SIZE - 1;
 	}
 
-- 
2.39.2