[PATCH v3 1/3] dt-bindings: usb: mtk-xhci: add a property for Gen1 isoc-in transfer issue

[Krzysztof Kozlowski]

On 20/12/2023 03:58, Chunfeng Yun wrote:
> For Gen1 isoc-in endpoint on controller before about SSUSB IPM v1.6.0, it
> still send out unexpected ACK after receiving a short packet in burst
> transfer, this will cause an exception on connected device, specially for
> a 4k camera.
> Add a quirk property "rx-fifo-depth" to work around this hardware issue,
> prefer to use 3k bytes;
> The side-effect is that may cause performance drop about 10%, including
> bulk transfer.
> 
> Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
> ---
> v3: add fifo depth unit, change the value range from 0-3 to 1-4
> v2: change 'mediatek,rxfifo-depth' to 'rx-fifo-depth'
> ---
>  .../devicetree/bindings/usb/mediatek,mtk-xhci.yaml   | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml b/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
> index e9644e333d78..9478b7031796 100644
> --- a/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
> +++ b/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
> @@ -124,6 +124,18 @@ properties:
>        defined in the xHCI spec on MTK's controller.
>      default: 5000
>  
> +  rx-fifo-depth:
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    description:
> +      It is a quirk used to work around Gen1 isoc-in endpoint transfer issue
> +      that still send out unexpected ACK after device finish the burst transfer
> +      with a short packet and cause an exception, specially on a 4K camera
> +      device, it happens on controller before about IPM v1.6.0; the side-effect
> +      is that may cause performance drop about 10%, include bulk transfer,
> +      prefer to use 3 here. The unit is 1K bytes.

NAK. Read comments on previous submission.

Best regards,
Krzysztof