[PATCH v4 6/9] riscv: dts: starfive: visionfive-v1: Setup ethernet phy

[Andrew Lunn]

On Mon, Dec 18, 2023 at 11:44:46PM +0200, Cristian Ciocaltea wrote:
> The StarFive VisionFive V1 SBC uses a Motorcomm YT8521 PHY supporting
> RGMII-ID, but requires manual adjustment of the RX internal delay to
> work properly.
> 
> The default RX delay provided by the driver is 1.95 ns, which proves to
> be too high. Applying a 50% reduction seems to mitigate the issue.
> 
> Also note this adjustment is not necessary on BeagleV Starlight SBC,
> which uses a Microchip PHY.  Hence, there is no indication of a
> misbehaviour on the GMAC side, but most likely the issue stems from
> the Motorcomm PHY.
> 
> While at it, drop the redundant gpio include, which is already provided
> by jh7100-common.dtsi.
> 
> Co-developed-by: Emil Renner Berthing <emil.renner.berthing at canonical.com>
> Signed-off-by: Emil Renner Berthing <emil.renner.berthing at canonical.com>
> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea at collabora.com>

Reviewed-by: Andrew Lunn <andrew at lunn.ch>

    Andrew