[PATCH 3/4] arm64: dts: ti: iot2050: Factor out arduino connector bits

[Krzysztof Kozlowski]

On 19/12/2023 09:06, Jan Kiszka wrote:
> On 19.12.23 08:51, Krzysztof Kozlowski wrote:
>> On 18/12/2023 17:35, Jan Kiszka wrote:
>>> From: Jan Kiszka <jan.kiszka at siemens.com>
>>>
>>> A new variant is to be added which will not have a arduino connector
>>> like the existing ones. Factor out all bits that are specific to this
>>> connector.
>>>
>>> The split is not perfect because wkup_gpio0 is defined based on what is
>>> common to all variants having the connector, thus containing also
>>> connector-unrelated information. But this is still cleaner than
>>> replicating this node into all 4 variants.
>>>
>>> Signed-off-by: Jan Kiszka <jan.kiszka at siemens.com>
>>> ---
>>>  .../ti/k3-am65-iot2050-arduino-connector.dtsi | 768 ++++++++++++++++++
>>>  .../boot/dts/ti/k3-am65-iot2050-common.dtsi   | 753 -----------------
>>
>> Please use proper -B/-M/-C arguments so code movements will be detected.
>>
> 
> Those are in place but have no impact, likely because the source file is

In place as what?

> still ~700 lines after the shuffling.

The original file has 720 lines, so if you move 750 (!) of them, I can
hardly believe the rename cannot be detected. You are basically moving
90% or 95% of file, so this must be represented with proper diff.

Your patches do not apply on next, neither on master, so it is tricky to
check.

How do you expect us to review it? Compare line by line?

Best regards,
Krzysztof