[PATCH v2 12/12] [UNTESTED] riscv: dts: starfive: beaglev-starlight: Enable gmac

[Cristian Ciocaltea]

On 12/16/23 21:24, Emil Renner Berthing wrote:
> Cristian Ciocaltea wrote:
>> On 11/28/23 02:40, Cristian Ciocaltea wrote:
>>> On 11/26/23 23:10, Emil Renner Berthing wrote:
>>>> Cristian Ciocaltea wrote:
>>>>> The BeagleV Starlight SBC uses a Microchip KSZ9031RNXCA PHY supporting
>>>>> RGMII-ID.
>>>>>
>>
>> [...]
>>
>>>> You've alse removed the phy reset gpio on the Starlight board:
>>>>
>>>>   snps,reset-gpios = <&gpio 63 GPIO_ACTIVE_LOW>
>>>>
>>>> Why?
>>>
>>> I missed this in v1 as the gmac handling was done exclusively in
>>> jh7100-common. Thanks for noticing!
>>
>> Hi Emil,
>>
>> I think the reset doesn't actually trigger because "snps,reset-gpios" is
>> not a valid property, it should have been "snps,reset-gpio" (without the
>> trailing "s").
>>
>> However, this seems to be deprecated now, and the recommended approach
>> would be to define the reset gpio in the phy node, which I did in [1].
>>
>> Hopefully this won't cause any unexpected behaviour. Otherwise we should
>> probably simply drop it.
>>
>> [1]: https://lore.kernel.org/lkml/20231215204050.2296404-8-cristian.ciocaltea@collabora.com/
> 
> Oh, nice catch! With your v3 patches the Starlight board still works fine and
> GPIO63 is correctly grabbed and used for "PHY reset".

Great, thanks a lot for retesting this!