[PATCH V5 3/3] tty: serial: uartps: Add rs485 support to uartps driver

[Lino Sanfilippo]

Hi,

On 13.12.23 14:00, Manikanta Guntupalli wrote:

>
> +/**
> + * cdns_rs485_rx_callback - Timer rx callback handler for rs485.
> + * @t: Handle to the timer list structure
> + */
> +static void cdns_rs485_rx_callback(struct timer_list *t)
> +{
> +	struct cdns_uart *cdns_uart = from_timer(cdns_uart, t, timer);
> +
> +	/*
> +	 * Default Rx should be setup, because Rx signaling path
> +	 * need to enable to receive data.
> +	 */
> +	cdns_rs485_rx_setup(cdns_uart);
> +}
> +
> +/**
> + * cdns_rs485_tx_callback - Timer tx callback handler for rs485.
> + * @t: Handle to the timer list structure
> + */
> +static void cdns_rs485_tx_callback(struct timer_list *t)
> +{
> +	struct cdns_uart *cdns_uart = from_timer(cdns_uart, t, timer);
> +
> +	cdns_uart_handle_tx(cdns_uart->port);

This is called without holding the port lock now. Are you sure the lock is not
needed? AFAIK the port lock is needed at least for accessing the circular
buffer.

> +
> +	/* Enable the TX Empty interrupt */
> +	writel(CDNS_UART_IXR_TXEMPTY, cdns_uart->port->membase + CDNS_UART_IER);
> +
> +	if (uart_circ_empty(&cdns_uart->port->state->xmit) ||
> +	    uart_tx_stopped(cdns_uart->port)) {
> +		timer_setup(&cdns_uart->timer, cdns_rs485_rx_callback, 0);
> +		mod_timer(&cdns_uart->timer, jiffies +
> +			  msecs_to_jiffies(cdns_uart->port->rs485.delay_rts_after_send));
> +	}
> +}

Regards,
Lino