[PATCH] ARM64: Implement arch_report_meminfo()

[Yang Shi]

On Fri, Dec 8, 2023 at 1:12 PM Christoph Lameter (Ampere) <cl at gentwo.org> wrote:
>
> X86 has information in /proc/meminfo showing the use of large mappings
> for the kernel direct map. This has now also become important for
> ARM since the kernel default CONFIG_RODATA_FULL_DEFAULT_ENABLED
> forces 4K PTE use for the direct map and users may not be aware
> of the performance impact of the increased TLB use etc.
>
> The output of /proc/meminfo on ARM64 is then after this patch:
>
> 4K page size:
>
> Hugepagesize:       2048 kB
> Hugetlb:               0 kB
> DirectMap4k:      155912 kB
> CONT DMap4k:        1176 kB
> DirectMap2M:      722944 kB
> CONT DMap2M:       28672 kB
> DirectMap1G:   534773760 kB
>
> 64K page size:
>
> Hugepagesize:     524288 kB
> Hugetlb:               0 kB
> DirectMap64k:      882624 kB
> CONT DMap64k:       19904 kB
> DirectMap512M:    534773760 kB
> CONT DMap512M:           0 kB
> DirectMap4096G:           0 kB
>
> Signed-off-by: Christoph Lameter <cl at linux.com>
>
> Index: linux/arch/arm64/mm/mmu.c
> ===================================================================
> --- linux.orig/arch/arm64/mm/mmu.c
> +++ linux/arch/arm64/mm/mmu.c
> @@ -66,6 +66,12 @@ u32 __boot_cpu_mode[] = { BOOT_CPU_MODE_
>    */
>   long __section(".mmuoff.data.write") __early_cpu_boot_status;
>
> +static atomic_t nr_pte;
> +static atomic_t nr_pmd;
> +static atomic_t nr_pud;
> +static atomic_t nr_pte_cont;
> +static atomic_t nr_pmd_cont;

These statistics are useful for debugging. However, why not use the
direct_pages_count[] array to save the counters like other
architectures, for example, x86, ppc and s390?

> +
>   /*
>    * Empty_zero_page is a special page that is used for zero-initialized data
>    * and COW.
> @@ -179,6 +185,7 @@ static void init_pte(pmd_t *pmdp, unsign
>                 pte_t old_pte = READ_ONCE(*ptep);
>
>                 set_pte(ptep, pfn_pte(__phys_to_pfn(phys), prot));
> +               atomic_inc(&nr_pte);
>
>                 /*
>                  * After the PTE entry has been populated once, we
> @@ -223,8 +230,10 @@ static void alloc_init_cont_pte(pmd_t *p
>
>                 /* use a contiguous mapping if the range is suitably aligned */
>                 if ((((addr | next | phys) & ~CONT_PTE_MASK) == 0) &&
> -                   (flags & NO_CONT_MAPPINGS) == 0)
> +                   (flags & NO_CONT_MAPPINGS) == 0) {
>                         __prot = __pgprot(pgprot_val(prot) | PTE_CONT);
> +                       atomic_inc(&nr_pte_cont);
> +               }
>
>                 init_pte(pmdp, addr, next, phys, __prot);
>
> @@ -249,6 +258,7 @@ static void init_pmd(pud_t *pudp, unsign
>                 if (((addr | next | phys) & ~PMD_MASK) == 0 &&
>                     (flags & NO_BLOCK_MAPPINGS) == 0) {
>                         pmd_set_huge(pmdp, phys, prot);
> +                       atomic_inc(&nr_pmd);
>
>                         /*
>                          * After the PMD entry has been populated once, we
> @@ -301,8 +311,10 @@ static void alloc_init_cont_pmd(pud_t *p
>
>                 /* use a contiguous mapping if the range is suitably aligned */
>                 if ((((addr | next | phys) & ~CONT_PMD_MASK) == 0) &&
> -                   (flags & NO_CONT_MAPPINGS) == 0)
> +                   (flags & NO_CONT_MAPPINGS) == 0) {
>                         __prot = __pgprot(pgprot_val(prot) | PTE_CONT);
> +                       atomic_inc(&nr_pmd_cont);
> +               }
>
>                 init_pmd(pudp, addr, next, phys, __prot, pgtable_alloc, flags);
>
> @@ -346,7 +358,7 @@ static void alloc_init_pud(pgd_t *pgdp,
>                    ((addr | next | phys) & ~PUD_MASK) == 0 &&
>                     (flags & NO_BLOCK_MAPPINGS) == 0) {
>                         pud_set_huge(pudp, phys, prot);
> -
> +                       atomic_inc(&nr_pud);
>                         /*
>                          * After the PUD entry has been populated once, we
>                          * only allow updates to the permission attributes.
> @@ -1486,3 +1498,35 @@ void ptep_modify_prot_commit(struct vm_a
>   {
>         set_pte_at(vma->vm_mm, addr, ptep, pte);
>   }
> +
> +#ifdef CONFIG_PROC_FS
> +void arch_report_meminfo(struct seq_file *m)
> +{
> +       unsigned long pagesize_in_kb = PAGE_SIZE / 1024;
> +
> +       seq_printf(m, "DirectMap%luk:    %8lu kB\n",
> +                       pagesize_in_kb,
> +                       (unsigned long)atomic_read(&nr_pte) * pagesize_in_kb);
> +
> +        seq_printf(m, "CONT DMap%luk:    %8lu kB\n",
> +                       pagesize_in_kb,
> +                       (unsigned long)atomic_read(&nr_pte_cont) * pagesize_in_kb);
> +
> +       pagesize_in_kb = PMD_SIZE / 1024;
> +
> +        seq_printf(m, "DirectMap%luM:    %8lu kB\n",
> +                       pagesize_in_kb / 1024,
> +                       (unsigned long)atomic_read(&nr_pmd) * pagesize_in_kb);
> +
> +       seq_printf(m, "CONT DMap%luM:    %8lu kB\n",
> +                       pagesize_in_kb / 1024,
> +                       (unsigned long)atomic_read(&nr_pmd_cont) * pagesize_in_kb);
> +
> +       pagesize_in_kb = PUD_SIZE / 1024;
> +
> +       seq_printf(m, "DirectMap%luG:  %10lu kB\n",
> +                       pagesize_in_kb >> 20,
> +                        (unsigned long)atomic_read(&nr_pud) * pagesize_in_kb);
> +}
> +#endif
> +
>