[PATCH 1/2] dt-bindings: phy: mediatek: tphy: add a property for force-mode switch

[Chunfeng Yun (云春峰)]

On Thu, 2023-11-30 at 09:03 +0100, Krzysztof Kozlowski wrote:
>  	 
> External email : Please do not click links or open attachments until
> you have verified the sender or the content.
>  On 30/11/2023 02:51, Chunfeng Yun (云春峰) wrote:
> >>> 3. How about we revise the description as follows for more
> >> precisely?
> >>>
> >>> mediatek,force-mode:
> >>>    description:
> >>>      The force mode is used to manually switch the shared PHY
> mode
> >>>      between USB and PCIe. When force-mode is set, the USB 3.0
> mode
> >>>      will be selected. This is typically required for older SoCs
> >>>      that do not automatically manage PHY mode switching.
> >>>      For newer SoCs that support it, it is preferable to use the
> >>>      "mediatek,syscon-type" property instead.
> >>>    type: boolean
> >>
> >> Again, what is force-mode? 
> > Our DE describe this behavior as force-mode, as you see, the driver
> 
> What is "DE"?
Hardware designer

> 
> > power down controller and reset pipe to set the mode directly we
> want,
> 
> So force-mode is driver behavior?
hardware supported, need software to set some registers

> 
> > but usually the phy controller switch to the mode automatically
> > according to the external signal, e.g. trapping pin, efuse etc.
> > 
> >> It looks like you wrote bindings for the
> >> driver behavior. Bindings describe hardware, not how the driver
> >> should
> >> behave. The property might be reasonable, but you must describe
> here
> >> hardware characteristics/issue/etc.
> 
> You must address this, in such case.
OK, I'll modify the description

Thanks

> 
> 
> 
> Best regards,
> Krzysztof
>