[PATCH v9 2/3] ARM64: dts: marvell: Fix some common switch mistakes

[Gregory CLEMENT]

Linus Walleij <linus.walleij at linaro.org> writes:

> Fix some errors in the Marvell MV88E6xxx switch descriptions:
> - The top node had no address size or cells.
> - switch0 at 0 is not OK, should be ethernet-switch at 0.
> - ports should be ethernet-ports
> - port at 0 should be ethernet-port at 0
> - PHYs should be named ethernet-phy@
>
> Reviewed-by: Andrew Lunn <andrew at lunn.ch>
> Reviewed-by: Florian Fainelli <florian.fainelli at broadcom.com>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>

Applied on mvebu/dt64

Thanks,

Gregory

> ---
>  .../dts/marvell/armada-3720-espressobin-ultra.dts  | 14 ++--
>  .../boot/dts/marvell/armada-3720-espressobin.dtsi  | 20 +++--
>  .../boot/dts/marvell/armada-3720-gl-mv1000.dts     | 20 +++--
>  .../boot/dts/marvell/armada-3720-turris-mox.dts    | 85 ++++++++++++----------
>  .../boot/dts/marvell/armada-7040-mochabin.dts      | 24 +++---
>  .../dts/marvell/armada-8040-clearfog-gt-8k.dts     | 22 +++---
>  arch/arm64/boot/dts/marvell/cn9130-crb.dtsi        | 42 +++++------
>  7 files changed, 115 insertions(+), 112 deletions(-)

-- 
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com