[PATCH v2 7/8] PCI: xgene: Do PCI error check on own line

[Rob Herring]

On Sun, Aug 27, 2023 at 8:37 AM Ilpo Järvinen
<ilpo.jarvinen at linux.intel.com> wrote:
>
> Instead of a if condition with a line split, use the usual error
> handling pattern with a separate variable to improve readability.
>
> No functional changes intended.
>
> Signed-off-by: Ilpo Järvinen <ilpo.jarvinen at linux.intel.com>
> ---
>  drivers/pci/controller/pci-xgene.c | 5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pci/controller/pci-xgene.c b/drivers/pci/controller/pci-xgene.c
> index 887b4941ff32..b7f338de160b 100644
> --- a/drivers/pci/controller/pci-xgene.c
> +++ b/drivers/pci/controller/pci-xgene.c
> @@ -163,9 +163,10 @@ static int xgene_pcie_config_read32(struct pci_bus *bus, unsigned int devfn,
>                                     int where, int size, u32 *val)
>  {
>         struct xgene_pcie *port = pcie_bus_to_port(bus);
> +       int ret;
>
> -       if (pci_generic_config_read32(bus, devfn, where & ~0x3, 4, val) !=
> -           PCIBIOS_SUCCESSFUL)
> +       ret = pci_generic_config_read32(bus, devfn, where & ~0x3, 4, val);
> +       if (ret != PCIBIOS_SUCCESSFUL)

Long term I think we want to replace these error codes with standard
linux ones. As PCIBIOS_SUCCESSFUL is 0, I would change this to just:

if (pci_generic_config_read32(bus, devfn, where & ~0x3, 4, val))
    return PCIBIOS_DEVICE_NOT_FOUND;


>                 return PCIBIOS_DEVICE_NOT_FOUND;
>
>         /*
> --
> 2.30.2
>