[PATCH v2] ARM: dts: imx6qdl-gw5904: add internal mdio nodes

[Tim Harvey]

Complete the switch definition by adding the internal mdio nodes.

This does not change behavior on Linux but is required if the dt is used
for U-Boot which requires the internal PHY ports to be defined for
DSA.

Signed-off-by: Tim Harvey <tharvey at gateworks.com>
Reviewed-by: Vladimir Oltean <vladimir.oltean at nxp.com>
---
v2: rebase and update commit log
---
 arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi | 29 +++++++++++++++++++
 1 file changed, 29 insertions(+)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
index 9594bc5745ed..3375b3fd8d4c 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
@@ -212,6 +212,27 @@ switch at 0 {
 			compatible = "marvell,mv88e6085";
 			reg = <0>;
 
+			mdio {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				sw_phy0: ethernet-phy at 0 {
+					reg = <0x0>;
+				};
+
+				sw_phy1: ethernet-phy at 1 {
+					reg = <0x1>;
+				};
+
+				sw_phy2: ethernet-phy at 2 {
+					reg = <0x2>;
+				};
+
+				sw_phy3: ethernet-phy at 3 {
+					reg = <0x3>;
+				};
+			};
+
 			ports {
 				#address-cells = <1>;
 				#size-cells = <0>;
@@ -219,21 +240,29 @@ ports {
 				port at 0 {
 					reg = <0>;
 					label = "lan4";
+					phy-handle = <&sw_phy0>;
+					phy-mode = "internal";
 				};
 
 				port at 1 {
 					reg = <1>;
 					label = "lan3";
+					phy-handle = <&sw_phy1>;
+					phy-mode = "internal";
 				};
 
 				port at 2 {
 					reg = <2>;
 					label = "lan2";
+					phy-handle = <&sw_phy2>;
+					phy-mode = "internal";
 				};
 
 				port at 3 {
 					reg = <3>;
 					label = "lan1";
+					phy-handle = <&sw_phy3>;
+					phy-mode = "internal";
 				};
 
 				port at 5 {
-- 
2.25.1