[PATCH] arm64: dts: marvell: add DTS for 7215-IXS-A1 board

[Natarajan Subbiramani]

From: Natarajan Subbiramani <natarajan.subbiramani.ext at nokia.com>

7215-IXS-A1 is an aggregation switch based on Marvell AlleyCat5X. This dts is
extracted from Marvell RD-AC5X and modified to adjust the default LED
configuration of Mangement port, specifically tailored for this platform.

These files have been taken from the Marvell SDK and lightly cleaned
up with the License and copyright retained.

Signed-off-by: Natarajan Subbiramani <natarajan.subbiramani.ext at nokia.com>
---
 arch/arm64/boot/dts/marvell/7215-ixs-a1.dts | 108 ++++++++++++++++++++
 arch/arm64/boot/dts/marvell/Makefile        |   1 +
 2 files changed, 109 insertions(+)
 create mode 100644 arch/arm64/boot/dts/marvell/7215-ixs-a1.dts

diff --git a/arch/arm64/boot/dts/marvell/7215-ixs-a1.dts b/arch/arm64/boot/dts/marvell/7215-ixs-a1.dts
new file mode 100644
index 000000000000..8c10c541590f
--- /dev/null
+++ b/arch/arm64/boot/dts/marvell/7215-ixs-a1.dts
@@ -0,0 +1,108 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (C) 2023 Nokia
+ * Copyright (C) 2021 Marvell
+ * Copyright (C) 2022 Allied Telesis Labs
+ */
+/*
+ * Device Tree file for Nokia 7215-IXS-A1
+ */
+
+/dts-v1/;
+
+#include "ac5-98dx35xx.dtsi"
+
+/ {
+	model = "7215-IXS-A1";
+	compatible = "marvell,rd-ac5x", "marvell,ac5x", "marvell,ac5";
+
+	aliases {
+		serial0 = &uart0;
+		spiflash0 = &spiflash0;
+		gpio0 = &gpio0;
+		gpio1 = &gpio1;
+		ethernet0 = &eth0;
+		ethernet1 = &eth1;
+	};
+
+	memory at 0 {
+		device_type = "memory";
+		reg = <0x2 0x00000000 0x0 0x40000000>;
+	};
+
+	usb1phy: usb-phy {
+		compatible = "usb-nop-xceiv";
+		#phy-cells = <0>;
+	};
+};
+
+&mdio {
+	phy0: ethernet-phy at 0 {
+		marvell,reg-init = <0x03 0x10 0x0 0x1140>;
+		reg = <0>;
+	};
+};
+
+&i2c0 {
+	status = "okay";
+};
+
+&i2c1 {
+	status = "okay";
+};
+
+&eth0 {
+	status = "okay";
+	phy-handle = <&phy0>;
+};
+
+/* USB0 is a host USB */
+&usb0 {
+	status = "okay";
+};
+
+/* USB1 is a peripheral USB */
+&usb1 {
+	status = "okay";
+	phys = <&usb1phy>;
+	phy-names = "usb-phy";
+	dr_mode = "peripheral";
+};
+
+&spi0 {
+	status = "okay";
+
+	spiflash0: flash at 0 {
+		compatible = "jedec,spi-nor";
+		spi-max-frequency = <50000000>;
+		spi-tx-bus-width = <1>; /* 1-single, 2-dual, 4-quad */
+		spi-rx-bus-width = <1>; /* 1-single, 2-dual, 4-quad */
+		reg = <0>;
+
+		#address-cells = <1>;
+		#size-cells = <1>;
+
+		partition at 0 {
+			label = "spi_flash_part0";
+			reg = <0x0 0x800000>;
+		};
+
+		parition at 1 {
+			label = "spi_flash_part1";
+			reg = <0x800000 0x700000>;
+		};
+
+		parition at 2 {
+			label = "spi_flash_part2";
+			reg = <0xF00000 0x100000>;
+		};
+	};
+};
+
+/{
+	sdma_drv {
+		compatible = "marvell,mvppnd";
+		interrupts = <GIC_SPI 0x23 IRQ_TYPE_LEVEL_HIGH>;
+		status = "okay";
+	};
+};
diff --git a/arch/arm64/boot/dts/marvell/Makefile b/arch/arm64/boot/dts/marvell/Makefile
index 79ac09b58a89..6c1bc9fafbf3 100644
--- a/arch/arm64/boot/dts/marvell/Makefile
+++ b/arch/arm64/boot/dts/marvell/Makefile
@@ -27,3 +27,4 @@ dtb-$(CONFIG_ARCH_MVEBU) += cn9132-db-B.dtb
 dtb-$(CONFIG_ARCH_MVEBU) += cn9130-crb-A.dtb
 dtb-$(CONFIG_ARCH_MVEBU) += cn9130-crb-B.dtb
 dtb-$(CONFIG_ARCH_MVEBU) += ac5-98dx35xx-rd.dtb
+dtb-$(CONFIG_ARCH_MVEBU) += 7215-ixs-a1.dtb

base-commit: 4853c74bd7ab7fdb83f319bd9ace8a08c031e9b6
-- 
2.25.1