[PATCH 1/2] arm64: dts: imx8mp: Fix SDMA2/3 clocks

[Adam Ford]

On Mon, Aug 14, 2023 at 3:22 AM Lucas Stach <l.stach at pengutronix.de> wrote:
>
> Am Sonntag, dem 13.08.2023 um 11:29 -0500 schrieb Adam Ford:
> > A previous patch to remove the Audio clocks from the main clock node
> > was intended to force people to setup the audio PLL clocks per board
> > instead of having a common set of rates since not all boards may use
> > the various audio PLL clocks for audio devices.
> >
> > Unfortunately, with this parenting removed, the SDMA2 and SDMA3
> > clocks were slowed to 24MHz because the SDMA2/3 clocks are controlled
> > via the audio_blk_ctrl which is clocked from IMX8MP_CLK_AUDIO_ROOT,
> > and that clock is enabled by pgc_audio.
> >
> > Per the TRM, "The SDMA2/3 target frequency is 400MHz IPG and 400MHz
> > AHB, always 1:1 mode, to make sure there is enough throughput for all
> > the audio use cases."
> >
> > Instead of cluttering the clock node, place the clock rate and parent
> > information into the pgc_audio node.
> >
> > With the parenting and clock rates restored for  IMX8MP_CLK_AUDIO_AHB,
> > and IMX8MP_CLK_AUDIO_AXI_SRC, it appears the SDMA2 and SDMA3 run at
> > 400MHz again.
> >
> Note that 800MHz for the AXI clock is overdrive mode for the chip. For
> other i.MX8M* chips we tried to have the nominal drive rates as
> assigned rates in DT. With the i.MX8MP it's currently a wild mix and
> most of the AXI clocks are set to OD rates, so I won't reject this
> patch based on this.
>
> Most boards run the DRAM at DDR4-4000, which already requires OD
> voltages, so there isn't much point in trying to stick to ND rates on
> those boards. We should probably do some consolidation here and come up
> with a proper policy for the i.MX8MP soon.

I didn't realize 800MHz was OD.  I just set it to the rate that it was
before the previous patch.  I think the defaults should be ND, and let
boards who need OD set them.  Unless someone objects, I'll submit a
V2.

adam
>
> > Fixes: 16c984524862 ("arm64: dts: imx8mp: don't initialize audio clocks from CCM node")
> > Signed-off-by: Adam Ford <aford173 at gmail.com>
>
> Reviewed-by: Lucas Stach <l.stach at pengutronix.de>
>
> >
> > diff --git a/arch/arm64/boot/dts/freescale/imx8mp.dtsi b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > index 6f2f50e1639c..408b0c4ec4f8 100644
> > --- a/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > +++ b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > @@ -790,6 +790,12 @@ pgc_audio: power-domain at 5 {
> >                                               reg = <IMX8MP_POWER_DOMAIN_AUDIOMIX>;
> >                                               clocks = <&clk IMX8MP_CLK_AUDIO_ROOT>,
> >                                                        <&clk IMX8MP_CLK_AUDIO_AXI>;
> > +                                             assigned-clocks = <&clk IMX8MP_CLK_AUDIO_AHB>,
> > +                                                               <&clk IMX8MP_CLK_AUDIO_AXI_SRC>;
> > +                                             assigned-clock-parents =  <&clk IMX8MP_SYS_PLL1_800M>,
> > +                                                                       <&clk IMX8MP_SYS_PLL1_800M>;
> > +                                             assigned-clock-rates = <400000000>,
> > +                                                                    <800000000>;
> >                                       };
> >
> >                                       pgc_gpu2d: power-domain at 6 {
>