[PATCH v1 4/5] arm64: dts: imx8mq-librem5-devkit: Drop power-supply

[Guido Günther]

Use a power sequence instead. As this handles the wifi disable line
rename the pincontrol accordingly. This also makes it similar to the
Librem 5.

Resolves following warning:

arch/arm64/boot/dts/freescale/imx8mq-librem5-devkit.dtb: mmc at 30b50000: Unevaluated properties are not allowed ('power-supply' was unexpected)
        from schema $id: http://devicetree.org/schemas/mmc/fsl-imx-esdhc.yaml#

Reported-by: David Heidelberg <david at ixit.cz>
Signed-off-by: Guido Günther <agx at sigxcpu.org>
---
 .../boot/dts/freescale/imx8mq-librem5-devkit.dts    | 13 ++++---------
 1 file changed, 4 insertions(+), 9 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq-librem5-devkit.dts b/arch/arm64/boot/dts/freescale/imx8mq-librem5-devkit.dts
index be9ef5c271df..244075e2a599 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq-librem5-devkit.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mq-librem5-devkit.dts
@@ -231,16 +231,11 @@ vibrator {
 		vcc-supply = <&reg_3v3_p>;
 	};
 
-	wifi_pwr_en: regulator-wifi-en {
-		compatible = "regulator-fixed";
+	wifi_pwrseq: pwrseq {
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_wifi_pwr_en>;
-		regulator-name = "WIFI_EN";
-		regulator-min-microvolt = <3300000>;
-		regulator-max-microvolt = <3300000>;
-		gpio = <&gpio3 5 GPIO_ACTIVE_HIGH>;
-		enable-active-high;
-		regulator-always-on;
+		compatible = "mmc-pwrseq-simple";
+		reset-gpios = <&gpio3 5 GPIO_ACTIVE_LOW>;
 	};
 };
 
@@ -1032,7 +1027,7 @@ &usdhc2 {
 	pinctrl-2 = <&pinctrl_usdhc2_200mhz>;
 	bus-width = <4>;
 	vmmc-supply = <&reg_usdhc2_vmmc>;
-	power-supply = <&wifi_pwr_en>;
+	mmc-pwrseq = <&wifi_pwrseq>;
 	broken-cd;
 	disable-wp;
 	cap-sdio-irq;
-- 
2.40.1