[PATCH v2 07/13] arm64: dts: ti: k3-am64: Enable OSPI nodes at the board level

[Andrew Davis]

On 8/8/23 9:17 AM, Nishanth Menon wrote:
> On 09:13-20230808, Andrew Davis wrote:
>> On 8/8/23 8:34 AM, Andrew Davis wrote:
>>> OSPI nodes defined in the top-level AM64 SoC dtsi files are incomplete
>>> and may not be functional unless they are extended with pinmux and
>>> device information.
>>>
>>> As the attached OSPI device is only known about at the board integration
>>> level, these nodes should only be enabled when provided with this
>>> information.
>>>
>>> Disable the OSPI nodes in the dtsi files and only enable the ones that
>>> are actually pinned out on a given board.
>>>
>>> Signed-off-by: Andrew Davis <afd at ti.com>
>>> Reviewed-by: Dhruva Gole <d-gole at ti.com>
>>> ---
>>
>> Oops, I see we have a new AM64 board in -next (tqma64xxl), I can either
>> rebase this again and enable the nodes in there. Or you can skip this
>> and the other AM64 patch in this series and I'll resend them next cycle
>> when that new board is settled.
> 
> we should respin this series taking the new boards into consideration -
> am64 and am62 both have new boards.
> 

No problem, v3 on the way.

Andrew