[PATCH v2 5/5] net: ti: icssg-prueth: am65x SR2.0 add 10M full duplex support
Md Danish Anwar
a0501179 at ti.com
Tue Aug 8 06:10:23 PDT 2023
On 08/08/23 4:44 pm, Roger Quadros wrote:
>
>
> On 07/08/2023 14:00, MD Danish Anwar wrote:
>> From: Grygorii Strashko <grygorii.strashko at ti.com>
>>
>> For AM65x SR2.0 it's required to enable IEP1 in raw 64bit mode which is
>> used by PRU FW to monitor the link and apply w/a for 10M link issue.
>> Note. No public errata available yet.
>>
>> Without this w/a the PRU FW will stuck if link state changes under TX
>> traffic pressure.
>>
>> Hence, add support for 10M full duplex for AM65x SR2.0:
>> - add new IEP API to enable IEP, but without PTP support
>> - add pdata quirk_10m_link_issue to enable 10M link issue w/a.
>>
>> Signed-off-by: Grygorii Strashko <grygorii.strashko at ti.com>
>> Signed-off-by: Vignesh Raghavendra <vigneshr at ti.com>
>> Signed-off-by: MD Danish Anwar <danishanwar at ti.com>
>> ---
>> drivers/net/ethernet/ti/icssg/icss_iep.c | 26 ++++++++++++++++++++
>> drivers/net/ethernet/ti/icssg/icss_iep.h | 2 ++
>> drivers/net/ethernet/ti/icssg/icssg_config.c | 6 +++++
>> drivers/net/ethernet/ti/icssg/icssg_prueth.c | 17 +++++++++++--
>> 4 files changed, 49 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/ti/icssg/icss_iep.c b/drivers/net/ethernet/ti/icssg/icss_iep.c
>> index 455c803dea36..527f17430f05 100644
>> --- a/drivers/net/ethernet/ti/icssg/icss_iep.c
>> +++ b/drivers/net/ethernet/ti/icssg/icss_iep.c
>> @@ -721,6 +721,32 @@ void icss_iep_put(struct icss_iep *iep)
>> }
>> EXPORT_SYMBOL_GPL(icss_iep_put);
>>
>> +void icss_iep_init_fw(struct icss_iep *iep)
>> +{
>> + /* start IEP for FW use in raw 64bit mode, no PTP support */
>> + iep->clk_tick_time = iep->def_inc;
>> + iep->cycle_time_ns = 0;
>> + iep->ops = NULL;
>> + iep->clockops_data = NULL;
>> + icss_iep_set_default_inc(iep, iep->def_inc);
>> + icss_iep_set_compensation_inc(iep, iep->def_inc);
>> + icss_iep_set_compensation_count(iep, 0);
>> + regmap_write(iep->map, ICSS_IEP_SYNC_PWIDTH_REG, iep->refclk_freq / 10); /* 100 ms pulse */
>> + regmap_write(iep->map, ICSS_IEP_SYNC0_PERIOD_REG, 0);
>> + if (iep->plat_data->flags & ICSS_IEP_SLOW_COMPEN_REG_SUPPORT)
>> + icss_iep_set_slow_compensation_count(iep, 0);
>> +
>> + icss_iep_enable(iep);
>> + icss_iep_settime(iep, 0);
>> +}
>> +EXPORT_SYMBOL_GPL(icss_iep_init_fw);
>> +
>> +void icss_iep_exit_fw(struct icss_iep *iep)
>> +{
>> + icss_iep_disable(iep);
>> +}
>> +EXPORT_SYMBOL_GPL(icss_iep_exit_fw);
>> +
>> int icss_iep_init(struct icss_iep *iep, const struct icss_iep_clockops *clkops,
>> void *clockops_data, u32 cycle_time_ns)
>> {
>> diff --git a/drivers/net/ethernet/ti/icssg/icss_iep.h b/drivers/net/ethernet/ti/icssg/icss_iep.h
>> index 9c7f4d0a0916..803a4b714893 100644
>> --- a/drivers/net/ethernet/ti/icssg/icss_iep.h
>> +++ b/drivers/net/ethernet/ti/icssg/icss_iep.h
>> @@ -35,5 +35,7 @@ int icss_iep_exit(struct icss_iep *iep);
>> int icss_iep_get_count_low(struct icss_iep *iep);
>> int icss_iep_get_count_hi(struct icss_iep *iep);
>> int icss_iep_get_ptp_clock_idx(struct icss_iep *iep);
>> +void icss_iep_init_fw(struct icss_iep *iep);
>> +void icss_iep_exit_fw(struct icss_iep *iep);
>>
>> #endif /* __NET_TI_ICSS_IEP_H */
>> diff --git a/drivers/net/ethernet/ti/icssg/icssg_config.c b/drivers/net/ethernet/ti/icssg/icssg_config.c
>> index ab648d3efe85..4c2b5d496670 100644
>> --- a/drivers/net/ethernet/ti/icssg/icssg_config.c
>> +++ b/drivers/net/ethernet/ti/icssg/icssg_config.c
>> @@ -210,6 +210,9 @@ void icssg_config_ipg(struct prueth_emac *emac)
>> case SPEED_100:
>> icssg_mii_update_ipg(prueth->mii_rt, slice, MII_RT_TX_IPG_100M);
>> break;
>> + case SPEED_10:
>> + icssg_mii_update_ipg(prueth->mii_rt, slice, MII_RT_TX_IPG_100M);
>> + break;
>> default:
>> /* Other links speeds not supported */
>> netdev_err(emac->ndev, "Unsupported link speed\n");
>> @@ -440,6 +443,9 @@ void icssg_config_set_speed(struct prueth_emac *emac)
>> case SPEED_100:
>> fw_speed = FW_LINK_SPEED_100M;
>> break;
>> + case SPEED_10:
>> + fw_speed = FW_LINK_SPEED_10M;
>> + break;
>> default:
>> /* Other links speeds not supported */
>> netdev_err(emac->ndev, "Unsupported link speed\n");
>> diff --git a/drivers/net/ethernet/ti/icssg/icssg_prueth.c b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
>> index b82a718fd602..216918162960 100644
>> --- a/drivers/net/ethernet/ti/icssg/icssg_prueth.c
>> +++ b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
>> @@ -1131,7 +1131,6 @@ static int emac_phy_connect(struct prueth_emac *emac)
>>
>> /* remove unsupported modes */
>> phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_10baseT_Half_BIT);
>> - phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_10baseT_Full_BIT);
>> phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_100baseT_Half_BIT);
>> phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_1000baseT_Half_BIT);
>> phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_Pause_BIT);
>> @@ -2081,13 +2080,20 @@ static int prueth_probe(struct platform_device *pdev)
>> goto free_pool;
>> }
>>
>> + if (prueth->pdata.quirk_10m_link_issue) {
>> + /* Enable IEP1 for FW in 64bit mode as W/A for 10M FD link detect issue under TX
>> + * traffic.
>> + */
>> + icss_iep_init_fw(prueth->iep1);
>
> This is the only place where IEP1 is used.
> You should add all IEP1 related code in this patch.
Sure Roger, I'll do that.
>
>> + }
>> +
>> /* setup netdev interfaces */
>> if (eth0_node) {
>> ret = prueth_netdev_init(prueth, eth0_node);
>> if (ret) {
>> dev_err_probe(dev, ret, "netdev init %s failed\n",
>> eth0_node->name);
>> - goto netdev_exit;
>> + goto exit_iep;
>> }
>> prueth->emac[PRUETH_MAC0]->iep = prueth->iep0;
>> }
>> @@ -2158,6 +2164,10 @@ static int prueth_probe(struct platform_device *pdev)
>> prueth_netdev_exit(prueth, eth_node);
>> }
>>
>> +exit_iep:
>> + if (prueth->pdata.quirk_10m_link_issue)
>> + icss_iep_exit_fw(prueth->iep1);
>> +
>> free_pool:
>> gen_pool_free(prueth->sram_pool,
>> (unsigned long)prueth->msmcram.va, msmc_ram_size);
>> @@ -2203,6 +2213,9 @@ static void prueth_remove(struct platform_device *pdev)
>> prueth_netdev_exit(prueth, eth_node);
>> }
>>
>> + if (prueth->pdata.quirk_10m_link_issue)
>> + icss_iep_exit_fw(prueth->iep1);
>> +
>> icss_iep_put(prueth->iep1);
>> icss_iep_put(prueth->iep0);
>>
>
--
Thanks and Regards,
Danish.
More information about the linux-arm-kernel
mailing list