[PATCH v7 11/13] coresight-tpdm: Add nodes for timestamp request
Suzuki K Poulose
suzuki.poulose at arm.com
Mon Aug 7 04:27:17 PDT 2023
On 25/07/2023 08:15, Tao Zhang wrote:
> Add nodes to configure the timestamp request based on input
> pattern match. Each TPDM that support DSB subunit has maximum of
> n(n<7) TPR registers to configure value for timestamp request
> based on input pattern match. Eight 32 bit registers providing
> DSB interface timestamp request pattern match comparison. And
> each TPDM that support DSB subunit has maximum of m(m<7) TPMR
> registers to configure pattern mask for timestamp request. Eight
> 32 bit registers providing DSB interface timestamp request
> pattern match mask generation. Add nodes to enable/disable
> pattern timestamp and set pattern timestamp type.
>
> Signed-off-by: Tao Zhang <quic_taozha at quicinc.com>
> ---
> .../ABI/testing/sysfs-bus-coresight-devices-tpdm | 57 +++++-
> drivers/hwtracing/coresight/coresight-tpdm.c | 205 ++++++++++++++++++++-
> drivers/hwtracing/coresight/coresight-tpdm.h | 16 ++
> 3 files changed, 272 insertions(+), 6 deletions(-)
>
> diff --git a/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm b/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
> index 66f9582..74a0126 100644
> --- a/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
> +++ b/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
> @@ -130,4 +130,59 @@ Description:
> to the index number. Before writing data to this sysfs file,
> "dsb_trig_patt_idx" should be written first to configure the
> index number of the trigger pattern mask which needs to be
> - configured.
> \ No newline at end of file
> + configured.
> +
> +What: /sys/bus/coresight/devices/<tpdm-name>/dsb_patt_idx
> +Date: March 2023
> +KernelVersion 6.5
> +Contact: Jinlong Mao (QUIC) <quic_jinlmao at quicinc.com>, Tao Zhang (QUIC) <quic_taozha at quicinc.com>
> +Description:
> + Read/Write the index number of the DSB tpdm pattern. Since
> + there are at most 8 TPR and TPMR registers for the parttern,
> + this value ranges from 0 to 7.
If it is only 0-7 and we read/write full registers, why not expose
individual registers as mentioned in the previous comments and avoid
multi-line output for "show" routines. You may even group the registers
under a directory structure to avoid confusion.
e.g, :
dsb_patt/
\- mask0 ... mask7
\- ts0 ... ts7
\- type0 ... type7
dsb_edge/
\- edcr0 ... edcr15
\- edcmr0 ... edcmr7
\- ctrl_idx
\- ctrl_idx_val
....
> +
> +What: /sys/bus/coresight/devices/<tpdm-name>/dsb_patt_val
> +Date: March 2023
> +KernelVersion 6.5
> +Contact: Jinlong Mao (QUIC) <quic_jinlmao at quicinc.com>, Tao Zhang (QUIC) <quic_taozha at quicinc.com>
> +Description:
> + Read a set of the pattern values of the DSB TPDM. Write a data
> + to configure the pattern corresponding to the index number.
> + Before writing data to this sysfs file, "dsb_patt_idx" should be
> + written first to configure the index number of the pattern which
> + needs to be configured.
> +
> +What: /sys/bus/coresight/devices/<tpdm-name>/dsb_patt_mask
> +Date: March 2023
> +KernelVersion 6.5
> +Contact: Jinlong Mao (QUIC) <quic_jinlmao at quicinc.com>, Tao Zhang (QUIC) <quic_taozha at quicinc.com>
> +Description:
> + Read a set of the pattern mask values of the DSB TPDM. Write a
> + data to configure the pattern mask corresponding to the index
> + number. Before writing data to this sysfs file, "dsb_patt_idx"
> + should be written first to configure the index number of the
> + pattern mask which needs to be configured.
> +
> +What: /sys/bus/coresight/devices/<tpdm-name>/dsb_patt_ts
> +Date: March 2023
> +KernelVersion 6.5
> +Contact: Jinlong Mao (QUIC) <quic_jinlmao at quicinc.com>, Tao Zhang (QUIC) <quic_taozha at quicinc.com>
> +Description:
> + (Write) Set the pattern timestamp of DSB tpdm. Read
> + the pattern timestamp of DSB tpdm.
> +
> + Accepts only one of the 2 values - 0 or 1.
> + 0 : Disable DSB pattern timestamp.
> + 1 : Enable DSB pattern timestamp.
> +
> +What: /sys/bus/coresight/devices/<tpdm-name>/dsb_patt_type
> +Date: March 2023
> +KernelVersion 6.5
> +Contact: Jinlong Mao (QUIC) <quic_jinlmao at quicinc.com>, Tao Zhang (QUIC) <quic_taozha at quicinc.com>
> +Description:
> + (Write) Set the pattern type of DSB tpdm. Read
> + the pattern type of DSB tpdm.
> +
> + Accepts only one of the 2 values - 0 or 1.
> + 0 : Set the DSB pattern type to value.
> + 1 : Set the DSB pattern type to toggle.
> \ No newline at end of file
> diff --git a/drivers/hwtracing/coresight/coresight-tpdm.c b/drivers/hwtracing/coresight/coresight-tpdm.c
> index 1c32d27..f9e5a1d 100644
> --- a/drivers/hwtracing/coresight/coresight-tpdm.c
> +++ b/drivers/hwtracing/coresight/coresight-tpdm.c
> @@ -69,6 +69,27 @@ static void set_dsb_perf_mode(struct tpdm_drvdata *drvdata, u32 *val)
> *val &= ~TPDM_DSB_CR_MODE;
> }
>
> +static void set_dsb_tier(struct tpdm_drvdata *drvdata, u32 *val)
> +{
> + /* Set pattern timestamp type and enablement */
> + if (drvdata->dsb->patt_ts) {
> + *val |= TPDM_DSB_TIER_PATT_TSENAB;
> + if (drvdata->dsb->patt_type)
> + *val |= TPDM_DSB_TIER_PATT_TYPE;
> + else
> + *val &= ~TPDM_DSB_TIER_PATT_TYPE;
> + } else {
> + *val &= ~TPDM_DSB_TIER_PATT_TSENAB;
> + }
> +
> + /* Set trigger timestamp */
> + if (drvdata->dsb->trig_ts)
> + *val |= TPDM_DSB_TIER_XTRIG_TSENAB;
> + else
> + *val &= ~TPDM_DSB_TIER_XTRIG_TSENAB;
> +
> +}
> +
> static void tpdm_enable_dsb(struct tpdm_drvdata *drvdata)
> {
> u32 val, i;
> @@ -81,6 +102,10 @@ static void tpdm_enable_dsb(struct tpdm_drvdata *drvdata)
> drvdata->base + TPDM_DSB_EDCMR(i));
>
> for (i = 0; i < TPDM_DSB_MAX_PATT; i++) {
> + writel_relaxed(drvdata->dsb->patt_val[i],
> + drvdata->base + TPDM_DSB_TPR(i));
> + writel_relaxed(drvdata->dsb->patt_mask[i],
> + drvdata->base + TPDM_DSB_TPMR(i));
> writel_relaxed(drvdata->dsb->trig_patt[i],
> drvdata->base + TPDM_DSB_XPR(i));
> writel_relaxed(drvdata->dsb->trig_patt_mask[i],
> @@ -88,11 +113,7 @@ static void tpdm_enable_dsb(struct tpdm_drvdata *drvdata)
> }
>
> val = readl_relaxed(drvdata->base + TPDM_DSB_TIER);
> - /* Set trigger timestamp */
> - if (drvdata->dsb->trig_ts)
> - val |= TPDM_DSB_TIER_XTRIG_TSENAB;
> - else
> - val &= ~TPDM_DSB_TIER_XTRIG_TSENAB;
> + set_dsb_tier(drvdata, &val);
> writel_relaxed(val, drvdata->base + TPDM_DSB_TIER);
>
> val = readl_relaxed(drvdata->base + TPDM_DSB_CR);
> @@ -462,6 +483,175 @@ static ssize_t dsb_edge_ctrl_mask_store(struct device *dev,
> }
> static DEVICE_ATTR_RW(dsb_edge_ctrl_mask);
>
> +static ssize_t dsb_patt_idx_show(struct device *dev,
> + struct device_attribute *attr,
> + char *buf)
> +{
> + struct tpdm_drvdata *drvdata = dev_get_drvdata(dev->parent);
> +
> + return sysfs_emit(buf, "%u\n",
> + (unsigned int)drvdata->dsb->patt_idx);
> +
> +}
> +
> +static ssize_t dsb_patt_idx_store(struct device *dev,
> + struct device_attribute *attr,
> + const char *buf,
> + size_t size)
> +{
> + struct tpdm_drvdata *drvdata = dev_get_drvdata(dev->parent);
> + unsigned long index;
> +
> + if ((kstrtoul(buf, 0, &index)) || (index >= TPDM_DSB_MAX_PATT))
> + return -EINVAL;
> +
> + spin_lock(&drvdata->spinlock);
> + drvdata->dsb->patt_idx = index;
> + spin_unlock(&drvdata->spinlock);
> +
> + return size;
> +
> +}
> +static DEVICE_ATTR_RW(dsb_patt_idx);
> +
> +static ssize_t dsb_patt_val_show(struct device *dev,
> + struct device_attribute *attr,
> + char *buf)
> +{
> + struct tpdm_drvdata *drvdata = dev_get_drvdata(dev->parent);
> + ssize_t size = 0;
> + unsigned long bytes;
> + int i = 0;
> +
> + spin_lock(&drvdata->spinlock);
> + for (i = 0; i < TPDM_DSB_MAX_PATT; i++) {
> + bytes = sysfs_emit_at(buf, size,
> + "Value: 0x%x\n", drvdata->dsb->patt_val[i]);
Please see my comment on the other patches.
> + if (bytes <= 0)
> + break;
> + size += bytes;
> + }
> + spin_unlock(&drvdata->spinlock);
> + return size;
> +}
> +
> +static ssize_t dsb_patt_val_store(struct device *dev,
> + struct device_attribute *attr,
> + const char *buf,
> + size_t size)
> +{
> + struct tpdm_drvdata *drvdata = dev_get_drvdata(dev->parent);
> + unsigned long val;
> +
> + if (kstrtoul(buf, 0, &val))
You have used the base for all such conversions inconsistently,
throughout the series. You can always stick to 0.
$ git grep kstrtoul drivers/hwtracing/coresight/coresight-tpdm.c
drivers/hwtracing/coresight/coresight-tpdm.c: ret = kstrtoul(buf, 10,
&val);
drivers/hwtracing/coresight/coresight-tpdm.c: ret = kstrtoul(buf, 10,
&val);
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&val)) || val < 0)
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&val)) || (val >= TPDM_DSB_MAX_LINES))
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&edge_ctrl)) || (edge_ctrl > 0x2))
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&val)) || (val & ~1UL))
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&val)) || (val & ~1UL))
drivers/hwtracing/coresight/coresight-tpdm.c: if ((kstrtoul(buf, 0,
&val)) || (val & ~1UL))
Suzuki
More information about the linux-arm-kernel
mailing list