PROBLEM: Broken or delayed ethernet on Xilinx ZCU104 since 5.18 (regression)

Nick Bowler nbowler at draconx.ca
Sat Aug 5 00:34:22 PDT 2023


On 2023-08-05, Andrew Lunn <andrew at lunn.ch> wrote:
>> > It was also commented out before that change. It could be that gpio
>> > controller is missing. Do you have the driver for the tca6416 in
>> > your kernel configuration?
>>
>> I have CONFIG_GPIO_PCA953X=y which I think is the correct driver?
>
> It does appear to be the correct driver. But check if it has
> loaded. It is an i2c device, so maybe you are missing the I2C bus
> master device?

That's it!  I needed to set

  CONFIG_I2C_CADENCE=y

and now things are working again!

Thanks,
  Nick



More information about the linux-arm-kernel mailing list