[PATCH 3/3] arm64: dts: Replace the IRQ number with the IRQID macro definition

[Huqiang Qin]

Hi Kevin,

On 2023/7/29 3:06, Kevin Hilman wrote:
>> On 2023/7/27 6:33, Kevin Hilman wrote:
>>>> Replacing IRQ numbers with IRQID macro definitions makes node properties
>>>> easier to understand and also makes GPIO interrupts easier to use.
>>>>
>>>> Associated platforms:
>>>> - Amlogic Meson-G12A
>>>> - Amlogic Meson-G12B
>>>> - Amlogic Meson-SM1
>>> Does this mean you tested/validated these changes on those platforms
>>> also?
>>
>> Amlogic's G12A/G12B/SM1 have the same GPIO, and the GPIO interrupt number
>> is also the same, so I only tested on the SM1 platform, and the test results
>> prove that these changes are good.
> 
> OK, thank you for the explanation.
> 
> For future reference, this kind of detail is helpful to describe in the
> patch or cover letter so maintainers & reviewers better understand how
> the changes were tested.

Thanks for the suggestion, I'll add it to the cover letter for the patch v3.
(patch v2 was sent before your reply)


Best Regards,
Huqiang Qin