[PATCH v2 1/2] dt-bindings: gpio: Add STMPE YAML DT schema

[Rob Herring]

On Wed, Apr 26, 2023 at 01:21:38PM +0200, Linus Walleij wrote:
> This adds a schema for the STMPE GPIO that while it is used a
> lot in the kernel tree is anyway missing its bindings.
> 
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
> ChangeLog v1->v2:
> - New patch split off from the MFD patch.
> ---
>  .../devicetree/bindings/gpio/st,stmpe-gpio.yaml    | 60 ++++++++++++++++++++++
>  1 file changed, 60 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/gpio/st,stmpe-gpio.yaml b/Documentation/devicetree/bindings/gpio/st,stmpe-gpio.yaml
> new file mode 100644
> index 000000000000..6e991ebbdf77
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/st,stmpe-gpio.yaml
> @@ -0,0 +1,60 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/gpio/st,stmpe-gpio.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: STMicroelectonics Port Expander (STMPE) GPIO Block
> +
> +description: STMicroelectronics Port Expander (STMPE) is a series of slow
> +  bus controllers for various expanded peripherals such as GPIO, keypad,
> +  touchscreen, ADC, PWM or rotator. It can contain one or several different
> +  peripherals connected to SPI or I2C. These bindings pertain to the
> +  GPIO portions of these expanders.
> +
> +maintainers:
> +  - Linus Walleij <linus.walleij at linaro.org>
> +
> +properties:
> +  compatible:
> +    const: st,stmpe-gpio
> +
> +  "#gpio-cells":
> +    const: 2
> +
> +  "#interrupt-cells":
> +    const: 2
> +
> +  gpio-controller: true
> +
> +  interrupt-controller: true
> +
> +  st,norequest-mask:
> +    description: A bitmask of GPIO lines that cannot be requested because for
> +      for example not being connected to anything on the system
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +
> +patternProperties:
> +  "^.+-hog(-[0-9]+)?$":
> +    type: object
> +
> +    properties:
> +      gpio-hog: true
> +      gpios: true
> +      input: true
> +      output-high: true
> +      output-low: true
> +      line-name: true
> +
> +    required:
> +      - gpio-hog
> +      - gpios

All you need for hog nodes is:

"^.+-hog(-[0-9]+)?$":
  type: object
  required:
    - gpio-hog

The presence of 'gpio-hog' causes the hog schema to be applied.

Rob