[PATCH v2 4/4] spi: cadence-quadspi: use STIG mode for small reads

[Dhruva Gole]

Hi,

On 27/04/23 06:11, Yoshitaka Ikeda wrote:
> Hi Dhruva,
> 
>> Please can you send me the register fields information for the CQSPI
>> controller used in this device?
>> I wanted to verify if atall there were any mismatch between the controller I
>> have tested with vs your SOC's controller.
> 
> You can find it in the pdf that can be obtained by pressing the download button in the upper right corner of the following website.
> - https://www.intel.com/content/www/us/en/docs/programmable/683126/15-0/introduction.html

Thanks for sharing, I went through and couldn't really find any major
changes at the controller level.
So I am wondering if some specific sequence of flash operations on your 
device is exposing some issues in the driver's STIG reads.


Please can you share some logs with the following patch:
I am trying to see a pattern that may be causing issues.
I am unable to reproduce this on my end at the moment.

...
diff --git a/drivers/spi/spi-cadence-quadspi.c 
b/drivers/spi/spi-cadence-quadspi.c
index 6ddb2dfc0f00..5fa71dbd37ef 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -1390,6 +1390,14 @@ static int cqspi_exec_mem_op(struct spi_mem *mem, 
const struct spi_mem_op *op)
         int ret;

         ret = cqspi_mem_process(mem, op);
+       /* debug */
+       printk("**********spi_mem_op dump**************");
+       printk("addr: nbytes:0x%X , buswidth 0x%X, dtr 0x%X, val 
0x%llX", op->addr.nbytes, op->addr.buswidth, op->addr.dtr, op->addr.val);
+       printk("cmd: nbytes:0x%X , buswidth 0x%X, dtr 0x%X, opcode 
0x%X", op->cmd.nbytes, op->cmd.buswidth, op->cmd.dtr, op->cmd.opcode);
+       printk("data: nbytes:0x%X , buswidth 0x%X, dtr 0x%X, data dir 
0x%X", op->data.nbytes, op->data.buswidth, op->data.dtr, op->data.dir);
+
+       printk("***************************************");
+       /* ---------------------------- */
         if (ret)
                 dev_err(&mem->spi->dev, "operation failed with %d\n", ret);


...

-- 
Thanks and Regards,
Dhruva Gole