[PATCH 0/5] arm64: dts: ti: k3-j7200: Add properties and sync with uboot

[Udit Kumar]

In continuation of patch series posted by Nishanth
for sync of uboot device tree with kernel device tree for AM64 SOC.
https://lore.kernel.org/linux-arm-kernel/20230414073328.381336-1-nm@ti.com/

This series extend device tree sync/clean up for J7200 SOC.

This patch series build on top of
https://lore.kernel.org/all/20230419040007.3022780-1-u-kumar1@ti.com


Udit Kumar (5):
  arm64: dts: ti: k3-j7200: Add general purpose timers
  arm64: dts: ti: k3-j7200: Configure pinctrl for timer IO pads
  arm64: dts: ti: k3-j7200-common-proc-board: main_pmx0 clean up
  arm64: dts: ti: k3-j7200-common-proc-board: Add uart pin mux in
    wkup_pmx0
  arm64: dts: ti: k3-j7200: Add bootph-pre-ram for u-boot

 .../dts/ti/k3-j7200-common-proc-board.dts     |  37 ++-
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 258 ++++++++++++++++++
 .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 138 ++++++++++
 arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi   |   3 +
 4 files changed, 432 insertions(+), 4 deletions(-)

-- 
2.34.1