[PATCH v8 10/11] tty: serial: Add Nuvoton ma35d1 serial driver support

[Christophe JAILLET]

Le 25/04/2023 à 12:24, Jacky Huang a écrit :
> From: Jacky Huang <ychuang3 at nuvoton.com>
> 
> This adds UART and console driver for Nuvoton ma35d1 Soc.
> It supports full-duplex communication, FIFO control, and
> hardware flow control.
> 
> Signed-off-by: Jacky Huang <ychuang3 at nuvoton.com>
> ---
>   drivers/tty/serial/Kconfig         |  18 +
>   drivers/tty/serial/Makefile        |   1 +
>   drivers/tty/serial/ma35d1_serial.c | 781 +++++++++++++++++++++++++++++
>   3 files changed, 800 insertions(+)
>   create mode 100644 drivers/tty/serial/ma35d1_serial.c
> 

[...]

> +static int ma35d1serial_probe(struct platform_device *pdev)
> +{
> +	struct resource *res_mem;
> +	struct uart_ma35d1_port *up;
> +	int ret = 0;
> +	struct clk *clk;
> +	int err;
> +
> +	if (pdev->dev.of_node) {
> +		ret = of_alias_get_id(pdev->dev.of_node, "serial");
> +		if (ret < 0) {
> +			dev_err(&pdev->dev, "failed to get alias/pdev id, errno %d\n", ret);
> +			return ret;
> +		}
> +	}
> +	up = &ma35d1serial_ports[ret];
> +	up->port.line = ret;
> +	res_mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> +	if (!res_mem)
> +		return -ENODEV;
> +
> +	up->port.iobase = res_mem->start;
> +	up->port.membase = devm_ioremap(&pdev->dev, up->port.iobase, UART_REG_SIZE);
> +	up->port.ops = &ma35d1serial_ops;
> +
> +	spin_lock_init(&up->port.lock);
> +
> +	clk = of_clk_get(pdev->dev.of_node, 0);

Does this...

> +	if (IS_ERR(clk)) {
> +		err = PTR_ERR(clk);
> +		dev_err(&pdev->dev, "failed to get core clk: %d\n", err);
> +		return -ENOENT;
> +	}
> +
> +	err = clk_prepare_enable(clk);

... and this be undone in the remove function?

CJ

> +	if (err)
> +		return -ENOENT;
> +
> +	if (up->port.line != 0)
> +		up->port.uartclk = clk_get_rate(clk);
> +
> +	ret = platform_get_irq(pdev, 0);
> +	if (ret < 0)
> +		return ret;
> +	up->port.irq = ret;
> +	up->port.dev = &pdev->dev;
> +	up->port.flags = UPF_BOOT_AUTOCONF;
> +
> +	platform_set_drvdata(pdev, up);
> +
> +	return uart_add_one_port(&ma35d1serial_reg, &up->port);
> +}

[...]