[RFC PATCH net-next 05/22] net: dsa: mt7530: read XTAL value from correct register

[arinc9.unal at gmail.com]

From: Arınç ÜNAL <arinc.unal at arinc9.com>

On commit 7ef6f6f8d237 ("net: dsa: mt7530: Add MT7621 TRGMII mode support")
bit mask macros were added under the MT7530_HWTRAP register to read the
crystal frequency. However, the value given to the xtal variable on
mt7530_pad_clk_setup() is read from the MT7530_MHWTRAP register instead.

It doesn't seem to matter as my testing on MCM and standalone MT7530 shows
the value is correctly read from both registers but change it anyway.

Tested-by: Arınç ÜNAL <arinc.unal at arinc9.com>
Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index e956ffa1eea8..30553044d4b7 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -406,7 +406,7 @@ mt7530_pad_clk_setup(struct dsa_switch *ds, phy_interface_t interface)
 	struct mt7530_priv *priv = ds->priv;
 	u32 ncpo1, ssc_delta, trgint, xtal;
 
-	xtal = mt7530_read(priv, MT7530_MHWTRAP) & HWTRAP_XTAL_MASK;
+	xtal = mt7530_read(priv, MT7530_HWTRAP) & HWTRAP_XTAL_MASK;
 
 	if (xtal == HWTRAP_XTAL_20MHZ) {
 		dev_err(priv->dev,
-- 
2.37.2