[PATCH V3 3/9] dt-bindings: pinctrl: qcom: Add support for ipq5018

[Krzysztof Kozlowski]

On 17/04/2023 08:13, Sricharan Ramabadhran wrote:
>>> +    tlmm: pinctrl at 1000000 {
>>> +        compatible = "qcom,ipq5018-tlmm";
>>> +        reg = <0x01000000 0x300000>;
>>> +        gpio-controller;
>>> +        #gpio-cells = <2>;
>>> +        gpio-ranges = <&tlmm 0 0 47>;
>>> +        interrupts = <GIC_SPI 208 IRQ_TYPE_LEVEL_HIGH>;
>>> +        interrupt-controller;
>>> +        #interrupt-cells = <2>;
>>> +
>>> +        uart2-state {
>>> +            pins = "gpio34", "gpio35";
>>> +            function = "blsp2_uart";
>>
>> Does not look like you tested the bindings. Please run `make
>> dt_binding_check` (see
>> Documentation/devicetree/bindings/writing-schema.rst for instructions).
> 
>    I ran it against the TOT, will run it this time on nxt and post V4.

I don't know what is TOT, but this would fail in every case on every tree.


Best regards,
Krzysztof