pinconf-single: pinctrl-single,bias-pull{up,down} bits help/explanation

[Haojian Zhuang]

On Sun, 16 Oct 2022 at 20:14, Marty E. Plummer <hanetzer at startmail.com> wrote:
>
> Greetings.
>
> What I'm having issue with is the pinctrl-single,bias-pull values. From
> commit abe4e4675dfc62b7f2328e2c4bce8b5bdcdff7c0 I get a bit of it, and I
> think I have it mostly figured out:
>
> // <[input] [enabled] [disabled] [mask]>;
> pinctrl-single,bias-pullup = <? 1 0 0x100>;
> pinctrl-single,bias-pulldown = <? 1 0 0x200>;
>
> using mask 0x100 to single out bit 8 and mask 0x200 to single out bit 9,
> enable values being simple binary on/off. What I don't get is how the
> input value is determined/calculated.
>
> Aside from the above mentioned commit for the am335x-pocketbeagle.dts,
> which uses a differing pullup control scheme, the only users I can find
> in the tree are a handful of hisi socs which I don't have a datasheet
> for to map their usage to register definitions and puzzle this out.
>
Excuse me for just noticing the email.

#define  PULL_DIS     0
#define  PULL_UP        0x100
#define  PULL_DOWN  0x200

// <[input] [enabled] [disabled] [mask]>

// If you want to pull-up, configure the pin as below.
pinctrl-single,bias-pullup = <PULL_UP  PULL_UP  0  PULL_UP>
// If you want to disable pull-up, configure the pin as below.
pinctrl-single,bias-pullup = <0  PULL_UP  0  PULL_UP>

It seems that the pin configuration in am335x-pocketbeagle.dts is wrong.
But I don't have the board to verify it.

And you can check the logic in pcs_pinconf_set().

Best Regards
Haojian