[PATCH v2 00/10] Add support for USB on STM32MP13

[Alexandre TORGUE]

Hi Fabrice

On 10/14/22 16:14, Fabrice Gasnier wrote:
> Add support for USBPHYC, USB Host and USB OTG on STM32MP13.
> Enable all these interfaces on STM32MP135F-DK board.
> Enable the STM32G0 UCSI driver as module.
> Dependency on PWR and PMIC regulator is tempoarily managed by using
> fixed regulators (resp in the SoC dtsi and the board dts files).
> The USB support is functional when these regulators gets enabled at
> boot time before entering the kernel.
> 
> Changes in v2:
> Adopt "usb" and "typec" generic node names
> 
> Amelie Delaunay (5):
>    ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131
>    ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131
>    ARM: dts: stm32: add USB OTG HS support on stm32mp131
>    ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk
>    ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk
> 
> Fabrice Gasnier (5):
>    ARM: dts: stm32: add PWR fixed regulators on stm32mp131
>    ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk
>    ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13
>    ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk
>    ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules
> 
>   arch/arm/boot/dts/stm32mp13-pinctrl.dtsi |  7 ++
>   arch/arm/boot/dts/stm32mp131.dtsi        | 81 ++++++++++++++++++++
>   arch/arm/boot/dts/stm32mp135f-dk.dts     | 95 ++++++++++++++++++++++++
>   arch/arm/configs/multi_v7_defconfig      |  2 +
>   4 files changed, 185 insertions(+)
> 

Series applied on stm32-next.

Cheers
Alex