[PATCH] net: stmmac: linkup phy after enabled mac when system resume

[Clark Wang]

Here is an issue: after enabled the WoL function, EQoS cannot send and
receive data after resumed because of the wrong setting of
MAC_CONFIGURATION register.

When enable the WoL function, stmmac_resume will call stmmac_hw_setup
and phylink_resume.
 - When do stmmac_hw_setup, it will reset the stmmac, and re-config the
   register GMAC_CONFIG with a fixed default value GMAC_CORE_INIT.
 - When do phylink_resume in stmmac_resume, it will call stmmac_mac_link_up in
   a workqueue. stmmac_mac_link_up will set the correct speed/duplex states
   provided by phy to the CONFIG register.

So when resume the stmmac, the workqueue of phylink_resume must be run after
the stmmac_hw_setup to ensure that the configuration of the CONFIG register
is correct.
In order to ensure this, put the place of phylink_resume consistent with
stmmac_open.
Make sure that stmmac_mac_link_up is called after stmmac_hw_setup even the
workqueue of phylink_resume is run immediately.

Signed-off-by: Clark Wang <xiaoning.wang at nxp.com>
---
 .../net/ethernet/stmicro/stmmac/stmmac_main.c | 20 +++++++++----------
 1 file changed, 10 insertions(+), 10 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 65c96773c6d2..79c9ea451a81 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -7515,16 +7515,6 @@ int stmmac_resume(struct device *dev)
 			return ret;
 	}
 
-	rtnl_lock();
-	if (device_may_wakeup(priv->device) && priv->plat->pmt) {
-		phylink_resume(priv->phylink);
-	} else {
-		phylink_resume(priv->phylink);
-		if (device_may_wakeup(priv->device))
-			phylink_speed_up(priv->phylink);
-	}
-	rtnl_unlock();
-
 	rtnl_lock();
 	mutex_lock(&priv->lock);
 
@@ -7539,6 +7529,16 @@ int stmmac_resume(struct device *dev)
 
 	stmmac_restore_hw_vlan_rx_fltr(priv, ndev, priv->hw);
 
+	mutex_unlock(&priv->lock);
+	if (device_may_wakeup(priv->device) && priv->plat->pmt) {
+		phylink_resume(priv->phylink);
+	} else {
+		phylink_resume(priv->phylink);
+		if (device_may_wakeup(priv->device))
+			phylink_speed_up(priv->phylink);
+	}
+	mutex_lock(&priv->lock);
+
 	stmmac_enable_all_queues(priv);
 	stmmac_enable_all_dma_irq(priv);
 
-- 
2.34.1